Specifications

1. This hot air furnace can be fueled by oil or gas
2. Euipped with Riello burner
3. with heat exchanger to get clean hot air

Applications

This hot air generator is widely used for providing stabe hot air flow in drying and heating process. The outlet temperature can be 80-350 degree C.

 

Principle

The fuel is burnt at firebox and the high temperature is produced. The quantity of heat will conduct to heated air through heat exchange device; the air will be discharged through fan after the temperature dropping below 250°C. The air need to be heated is sent to hot air furnace through distribution blower. After absorbed heat to rated value, the air will be sent from hot air vent. When the air temperature reaches the rated upper limit, burner will stop or turn to small fire automatically. When air temperature drops to the rated low limit, burner will burn or turn to big fire automatically. The rate of temperature increase could be adjusted by inlet air valve.

 

Technical Parameters

model	oil combustion	heat supply capacity×104kcal/h	overall dimensionmm	hot air holemm	weightkg
RLY1	1.3-1.6	1	1000×1000×1600	200	750
RLY4	5-6.5	4	1700×1000×1600	140×160	1100
RLY10	13-16	10	2100×1300×1600	180×200	1970
RLY20	26-32	20	2800×14000×1700	200×250	2260
RLY30	39-48	30	3400×1500×1800	250×300	3160
RLY40	52-64	40	4020×1700×1900	300×400	4750
RLY60	78-96	60	4800×1900×2100	400×500	5650
RLY100	130-160	100	5400×2100×2300	550×650	6550
RLY200	260-320	200	6000×2500×2400	750×900	7980
RLY360	468-720	360	7200×2900×2600	900×1200	9860