Product Details

Product Description

rfid reader access control system full height gate

The full-height turnstile is designed for use in external entrances to Administrative Centres Industrial Complexes and Military Establishments where high quality, combined with high security full height barriers are required.

Entry and Exit can be made by Card reader, Pushbutton or any other type of control device specified by the client at the time of order.

An all welded steel rotor with straight arms runs in a phosphor bronze bearing at the top end and supported by a ball and cone bearing at the base

On double units the rotors can be interlocked where space is of prime importance.
Entry and Exit can be made by Card reader, Pushbutton or any other type of control device specified by the client at the time of order.

power supply voltage	AC220V ± 10 v, 50 hz	passing speed	30 people/minutes (IC card)
working environment	- 15 ℃ ~ 60 ℃	motor	20 w / 24 v
the relative humidity	less than 95%, no gel	Arm length	500mm
Pass width	600 mm or less	Open signal	Relay

Main Features

1) Automatically low noise mechanism core equipped,highly cost-performance

2) Sense positioning ,reducing mechanical impact make lifetime longer

3) Operating efficiency,1~2 seconds open & close

4)Lowest Noise : No matter in operating or outside control ,Noise control under 30db

5)Self-checking and Alarm warning for maintain

6)Resetting :System cancel authorized pass if passenger delayed pass

7)Anti following : prevent illegal passing

8)Anti clamp :The wings will stopped during in external block .the wings reset again after default delay

9)The rotary wings will be locked automatically if the system do not receive IR signal

10)Multi-passage for variety application demands ,Cover 99% needs on earth

11)Programmable signal separate control : pass time,pass speed etc. parameters

12)RS232/RS485 interface meet all kind of communications or WIRELESS connection

13)Compatible IC/ID card ,flexible couple

14)Anti-fraud single-user throughput

15)Customize Options : LED display,Voice guide ,Warning Lamps,Indicator Lights guide, Audible &Visible Alarm

Details

Daily Mantain

1. Ensure the electrical supply is isolated.

2. Open the Servicing Hatch in the Ceiling Panel.

3. Check the action of the KICK OUT SPRINGS to ensure correct working action.

4. Check that the RESTORING and DAMPING MECHANISMS (when fitted) function correctly.

5. Inspect the ROTOR for signs of wear or damage

6. Replace the Service Hatch.

7. Switch on the electrical supply.

8. Check the operation of the system.

9. Finally ensure all screws are fitted and secure.

Packing & Delivery

Certificate