Product Details

Product Description

The full-height turnstile is designed for use in external entrances to Administrative Centres, Industrial Complexes and Military Establishments where high quality, combined with high security full height barriers are required.

Power for the unit is 24V DC derived from a mains input transformer and rectifier circuit.
A positive action lock which prevents two passages at one time.
All controls are housed within the unit, therefore NO separate switches or control boxes are required.
A self-centering mechanism to ensure complete rotation of the head to the reset position.

power supply voltage	AC220V ± 10 v, 50 hz	passing speed	30 people/minutes (IC card)
working environment	- 15 ℃ ~ 60 ℃	motor	20 w / 24 v
the relative humidity	less than 95%, no gel	Drive	Manually Operated
Pass width	600 mm or less	Open signal	Relay

Main Features

1) Automatically low noise mechanism core equipped,highly cost-performance

2) Sense positioning ,reducing mechanical impact make lifetime longer

3) Operating efficiency,1~2 seconds open & close

4)Lowest Noise : No matter in operating or outside control ,Noise control under 30db

5)Self-checking and Alarm warning for maintain

6)Resetting :System cancel authorized pass if passenger delayed pass

7)Anti following : prevent illegal passing

8)Anti clamp :The wings will stopped during in external block .the wings reset again after default delay

9)The rotary wings will be locked automatically if the system do not receive IR signal

10)Multi-passage for variety application demands ,Cover 99% needs on earth

11)Programmable signal separate control : pass time,pass speed etc. parameters

12)International standard Relay gate openning signal

13)Compatible IC/ID card ,flexible couple

14)If the passenger does not access in the valid time, the gate will be locked up again. the valid passing time can be set up by operator.

15)Customize Options : LED display,Voice guide ,Warning Lamps,Indicator Lights guide, Audible &Visible Alarm

Parts

Daily Mantain

Routine Maintenance

1. Ensure the electrical supply is isolated.

2. Open the Servicing Hatch in the Ceiling Panel.

3. Check the action of the KICK OUT SPRINGS to ensure correct working action.

4. Check that the RESTORING and DAMPING MECHANISMS (when fitted) function correctly.

5. Inspect the ROTOR for signs of wear or damage

6. Replace the Service Hatch.

7. Switch on the electrical supply.

8. Check the operation of the system.

9. Finally ensure all screws are fitted and secure.

Packing & Delivery