T-shirt flash cure, Infra-Red/Hot-Air Dryers

Technical parameters:

Supply power: 220V / 380V, 50 / 60Hz

Power: 5.5KW

Working speed: 0-12m / min

Load weight: 15kg

Drying cabinet size: 800x400mm

Machine size: 1500x600x640mm

Net weight: 57kg

Gross weight: 72kg

Packing size: 1200x700x880mm

Characteristics:

1.       The machine adopts far-infrared heating tubes arranged uniformly in the oven;

2.       The machine adopts two parts heating tubes independent controlled in the belt, the operator can according to the need to open or close the heating tubes.

3.       The fan in the oven can ensure the temperature in the cabinet well distributed

4.       The machine adopts the electronic grade variable transmission, the speed of the motor is stable and adjustable, and the adjusting range is extensive, when the dry goods go through the 80 centimeters drying tunnel, the slowest speed is up to 50-60 seconds.

5.       The machine can work continuously for more than 8 hours, long life, low noise

6.       There are special designed finishing platform at the entrance; and there are damper regulator at the entrance and exist, these can ensure the heat stability.

7.       The conveyor belt is stainless steel mesh belt, the other parts adopt advanced electrostatic spraying, easy to clean, no rust.

8.       The package is excellent the machine adopts export level fumigation-free packing plate, the transportation is very convenient.

9.       The application is widely, and it can be applied to various need heating drying products.

Operation procedures:

1.       Power on, turn on the power switch, start the conveyor belt, pre-heating about 5 minutes. Open the fan switch (noted: when the machine is in the working state, the fan switch must be open) at this time according to the need of the baking content, adjust the room temperature, adjust the knob and the conveying speed, after debugging to the use requirement, it can start normal drying.

2.       After operation, turn of the heating switch, make the delivery motor and the hot air motor to continue running 5-10 minutes or so, and then cut off the power supply.