TJD series type NTC Thermistor
Negotiable /Piece
Min.Order:2000 Pieces
TJD Series(NTC Thermistor with Polyamide Film)
♦Insulation film coated, rapid response and high sensitivity
♦High stability and reliability
♦Superior insulation
♦High precision of resistance value
♦It is possible to use with safety in ambience that might
contact with electrodes
♦So small, light and solid in structure as to be convenient
for auto mounting (to a printed circuit board)
INTRODUCTION:
TJD series insulation film NTC thermistor is made by whole-newly technique, and it has the virtue of novel configuration, high
reliability and good coherence. It can be used in such occasions as temperature measurement, control and compensation.
APPLICATION:
Computer, Printer, Home Appliances, and so on.
CHARACTERISTIC:
♦Insulation film coated, rapid response and high sensitivity
♦High stability and reliability
♦Superior insulation
♦High precision of resistance value
♦It is possible to use with safety in ambience that might contact with electrodes
♦So small, light and solid in structure as to be convenient for auto mounting (to a printed circuit board)
MAIN TECHNOLOGY PARAMETER:
♦Rated zero power resistance @25℃ (R25℃): 10KΩ ~ 100KΩ
♦Allowance tolerance of R25℃: F±1%, G±2%, H±3%, J±5%
♦Range of B value (B25/50℃): 3380K; 3950K
♦Allowance tolerance of B-value: E±0.5%, F±1%, G±2%
♦Dissipation coefficient: 0.7mW/℃ (in still air)
♦Thermal time constant: ≤5S (in still air)
♦Operating temperature: -30 ~ +125℃
♦Rated power: <3.5mW
PART NO.:
(1)TJD:is insulation film NTC thermistor
(2)Rated resistance:103 is 10KΩ
(3)Allowable tolerance code:F±1%, G±2%, H±3%, J±5%
(4)B-value:3380 namely 3380K
DIMENSION(mm):
Total Length (4 types): 18mm, 25mm, 50mm, 75mm
NOTICE:
(1) Don’t fold lead frame of thermistor at random in case of bad resistance value caused by the strip between chip and
lead frame;
(2) Don’t let temperature exceed 300℃ when soldering, and the time not exceed 0.5 second at better;
(3) Use heat wind gun when adding heat-shrink tube, the temperature should be controlled by 120℃;
(4) Use constant temperature iron when soldering, the head of iron should be flat; one hand takes thermistor,
the other takes wire and doing contact soldering, it can enhance manufacture efficiency and shorten the soldering time;
(5) Special notice: don’t touch chip by hands (namely the top of thermistor) !