Hot Wireless Magnetic Vehicle Detection Sensor for Counting Car Accurately

1. Wireless Magnetic Vehicle Detector Replace Loop

WVD130X wireless vehicle detector is based on magnetic induction technology and wireless communication technology. It can be easily installed on road without any wiring needs. It can collect data of traffic flow, speed of vehicle, occupancy ratio and moving direction, providing these to system integrator. 

The WVD wireless vehicle detection sensor is designed for pursuit of high efficiency and low cost ITS traffic application systems. Based on magnetic detection and wireless sensor network, WVD sensors acquire the dynamic traffic flow information and send through wireless channel to user systems. 

Rosim ITS is successes in creating the WVD series wireless vehicle detector products and WAP series wireless access point, which build up a realtime wireless vehicle detection solution and traffic information monitoring system. In the past 5 more years, Rosim wireless vehicle detecting products had successfully replaced loops to monitor vehicles and the relative velocity, occupy rate and traffic flow in many projects of artery, freeway and intersection applications.

2. Principle and Technology

By capture the tiny change of magnetism caused by the passing vehicle, WVD (Wireless Vehicle Detector) in the Wireless vehicle detection system calculate the vehicle velocity, length, type and occupy rate rapidly, and then send these information to the WAPs (Wireless Access Points), which will receive all on line WVDs’ information and transmit these data to the user systems through RS-232/485, Ethernet, GPRS, etc.

3. Parameters

4. Features

5. Advantages

a)  Install fast. It is only almost 6 minutes that is needed to install one WVD detector in the road, after installation, the traffic control could be released immediately;

b)  Work all-weather. Bad weather for example heavy fog, snow and rain makes no difference;

c)  No damage to the road. There’s no need to cut slots on the road surface and place cables or wires as the installation of loops, but only a tiny hole with the size Φ 120/H 100 mm, which makes WVDs become the most suitable vehicle detecting solution on the city high-way and bridges;

d)  About 10 years long life span. With high standard water proof and anti-press characteristics,  WVD wireless vehicle detector can even be used in the damaged or distorted roads where loops cannot be installed.

e)  Cost saving. 

f)  Easy to maintain. Unlike the loops that are easily to be damaged but difficultly to be repaired, WVD wireless vehicle detector supports firmware updating over the air. No need to re-cut the slots, no more materials needed, and all of what you need is to take almost 10 minutes for the devices wireless updating;

g)  Low operation consuming. Due to the ultra-low power design and battery supply solution, WVD wireless vehicle detector’s consumed power is very lower than any other detectors like loops, video, micro-wave etc. in the market. This appears more and more significantly to our environments;

h)  Replace loops seamlessly. The same installation position and compatible output signals makes it easily and simply to replace loops in your system directly.

6. Compared with Loops

7. Applications

(1) Adaptve Traffic Signal Control System

(2)Travel Information System

(3)Traffic Flow Monitoring System

(4)Red Light and Speed Enforcement

(5)Corridor Management

 8.Maintenance and Support

 1. All of inquiry will be replied you within 24 hours.