Specifications

car logo door light,led car logo door projector light . the fourth generation led car door logo laser projector light.

Advantage:
1. The high power auto logo LED door light is specially designed for auto modification fancier; we purpose to bring more driving fun to drivers;
2. The dazzle logo light will display on the ground when you open the car door ,and will turn off when you close the door;
3. Major Reduction in, Heat Generation;
4. High ability of shock resistant; Brighter light; Low temperature
5. Super white lighting provides a high level of road safety at night driving;
6. It can be installed in both left and right door.Courtesy door light make your car artistic moreover the atmosphere;
7. Pure color with nice appearance.

Specification:
*Decorative lights
*LED chip:CREE
*Size: A:18x37mm  B:18x35mm
*Bit diameter:18.5mm
*Clour:black
*Voltage:DC 12V; Power:3W
*Light output:600LM
*Light source type:LED
*colour temperature:7000K
*Light source life:40000h
*wires length:1.8m
*Projection distance:15cm-55cm
*Projection diameter:10cm-45cm
*Emitting color:green,blue,red
*Operating Temp:-40 to +105°C
*Available for all cars

User Manuel:

1. this product is specially designed for auto modification fancier,we purpose to bring more driving fun to drivers;

2. the dazzle logo light will display on the ground when you open the car door,and will turn off when you close the door.

3. it can be installed in both left and right door,Courtesy door light make your car artistic moreover the atmosphere.

4. Embedded type design will not destroy the original car appearance.

Installation:

1. This product should be installed at the bottom of the door flame and make sure the len vertical with the ground.;

2. Pull down the inside door board first,Mark the suitable location for drilling a hole.

3. Drill the hole on the door board with our borer;

4. Inset the product from the bottom of car door,then arrange the power cord.

5. Install the nut through the power cord upon the hole inside, tighten the nut;

6. Connect the power cord according to the installation guide.

7. Adjust the lamp projection to the suitable place with wrench tool.

8. Reinstall the inside door board ,then check the final effect.

Attention:

    We strongly suggent installing this product by professional Automobile Modify Factory or Workshop,The Manufactuers disclaim all reponsibility for belongings or personal casualty caused by improper installation or misuse.

    It is better not to keep the product working more than 60Minutes to avoid damaging its lifepan.

    Please access the positive and negative poles of the power through voltage regulator rectifier , Do not direct acceslts to car battery.

Colour box :

And we can also design more colour box with your company's logo.

Other Pictuer:

More car logo,please contact us!