QS series squirrel-cage shot blasting machine is the special equipmentused that can clean automobile engine block and the cover.

The working principle of the machine:

The squirrel cage works with the cycle in the cleaning chamber, automatic loading and unloading of the workpiece, auto cycle, no downtime handling workpiece. It can clean up the five workpieces in the cleaning chamber,That is to say where there are 5 squirrel cage working simultaneously.there is the high cleaning efficiency, good cleaning effect, low maintenance and so on. It applies blaster engine block and other complex parts.If a little more detail ,as the following:

The push rod pushed the workpiece into the casting squirrel cage, and then the workpiece comes into the blasting room by squirrel cage, in the inner, two longitudinal squirrel cage roller driven to rotate while receiving the projectile. After cleaning the squirrel cage,laterally coming  into the separation station, continue to turn, inside the projectile casting poured. Then enter the place of discharge, squirrel cage stops, unloading pusher will launch casting squirrel cage.

Technical parameters of squirrel cage shot blasting machines

Packaging: Our packaging is suitable for the sea shipment.

Delivery: We will depending on the type of machine you buy delivery in 10-30 days.

In the routine maintenance of shot blasting machine , we should regularly check up blast wheel and the tight situation of the hoist, and be tightened promptly. In addition that,in case it was found shot blasting a greater shock, you should immediately stop the operation of the machine and check the emphasis o situation of the blasting impeller and wear parts, the timely replacement of worn parts.

1. In the process of cage type shot blasting machine work, you should put the workpiece into the cleaning room as much as possible, the goal is to reduce the blasting machine guard and increase service life of wear, at the same time improve the efficiency of the blast cleaning.

2. If there are no way to increase the workpiece , we must adjust the direction, so that the flow of steel shot more mass ejection ejection on the workpiece, reduce the wear and tear on guard and improve life.

3. The dust removal system branch should be adjusted around the valve,it will make wind distribution is reasonable, enhancing the dust removal effect.

4. Regularly clean the dust of the dust removal system, improving efficiency.  

1.Reply your inquiry in 24 working hours.

2.Experienced staffs answer all your questions in time.

3.Customized design is available.

4.Exclusive and unique solution can be provided to our customer by our well-trained and professional engineers and staff.

5.Special discount and protection of sales are provided to our distributor.

6.Professional factory:We are manufacturer, specializing in producing all kinds of Shot Blasting Machine & Molding Machine & Core Shooting Machine for more than 40 years, competitive with good quality.

7.As an honest seller, we always use superior raw material, advanced machines, skilled technicians to ensure our products to be finished in high quality and stable feature.