Specifications
ptfe joint sealant1.one part,high strength,red paste
2.a soft purple layer after cured
3.fill 0.20mm gap
4.50ml/soft tube
Kafuter K-0510 Flange ptfe Joint Sealant
Application
(1) Fill the gap of 0.2mm, it seals colse fitting joints between rigid metal surfaces and flanges and will flex with minor flange movements.
(2) used as a form-in-place gasket for pumps, thermostats, compressors, transmission housings and axle covers. especially sealing of the rigid-structured flange in gear boxes, engine crankcases, and flange plates, etc.
Characteristics
One-part, general purpose, high intensity anaerobic flange sealant, can replace any gasket instantly, good medium resistance, can form a soft layer after cured.
It cured when confined in the absence of air between close fitting metal surfaces.
Typical properties
Appearance | red paste |
Viscosity(cps/25°c) | ≥220000 |
Specific Gravity | 1.05~1.15 |
Flash Point(°c) | >108 |
Initial Cure Time(min) | ≤60 |
Full Cure Time(25°c) | 24h |
Max Seal Pressure | ≥36 |
Work Temperature(°C) | -54~150 |
Storage Life(25°c) | 12 months at 15°c~28°c |
Packing Specifications
50ml/soft tube | 10tube/box | 100tube/carton |
300ml/plastics tube | 30tube/box |
|
User's Guide
1. For best performance bond surfaces should be clean and free from grease.
2. The product is designed for close fitting flanged parts with gaps up to 0.25mm.
3. Apply manually as a continuous bead or by screen printing to one surface of the flanges.
4. Low pressures (<0.2mm) may be used when testing to confirm a complete seal immediately after assembly and before curing.
5. Flanges should be tightened as soon as possible after assembly to avoid shimming.
