UNS N08810 incoloy 800h bar
USD $1 - $30 /Kilogram
Min.Order:50 Kilograms
Wenzhou Jinhe Special Material Manufacture Co., Ltd.
n08810
INCOLOY alloy 800H
(UNS N08810)
It had been known for some time that higher carbon
alloy 800 had higher creep and rupture properties than
low-carbon material. For that reason, Special Metals
had melted to a carbon range of 0.05 to 0.10% except
for special orders where customers specified a lower
carbon content. The carbon range of 0.05 to 0.10% is
within the ASTM and ASME specification limits for
alloy 800 and is in the upper portion of that range.
Special Metals generated data for this material and
presented them to the ASME Code. The Code approved
higher design stresses for Section I and Divisions 1 and
2 of Section VIII, which appeared in Code Case 1325-
7. Note that alloy 800H required not only a carbon
range of 0.05 to 0.10% but also an average grain size of
ASTM 5, or coarser.
With the issuance of Code Case 1325-7 and the
common use of the term “800H”, there was no longer a
need to refer to “Grade 2” because it was replaced by
800H, and the material that had been called Grade 1
became, simply, INCOLOY alloy 800.
Available Product Forms:
Rod, bar, forgings, wire, plate, sheet, strip, pipe, tube, pipe fittings.
Specifications
INCOLOY alloy 800H is designated as UNS N08810 and Werkstoff Number 1.4958. It is listed in NACE MR0175 for oil and gas service.
Rod, Bar, Wire and Forging Stock: ASTM B564, ASTM B408.
Plate, Sheet and Strip: - ASTM B 409;
Pipe & Tube: ASTM B407, ASTM B163;
Pipe fittings: ASTM B366 WPNIC10
Chemical Composition
Nickel 30.0-35.0
Chromium 19.0-23.0
Iron. 39.5 min.
Carbon 0.05-0.10
Aluminum 0.15-0.60
Titanium 0.15-0.60
Aluminum + Titanium 0.30-1.20
specifications:
we are professional manifacturer focus on n08810 ,any question pls feel free to send us inquires.