Pall  HC2237FDT6H suction filter elements are extremely permeable and are constructed of high dirt capacity stainless steel (type 304 or 316L) woven wire mesh. pressure filter element media out perform other meshes because they are sintered woven wire meshes with higher void space.

more pores per unit area, providing more dirt-holding capacity than that of an unsintered mesh made from coarser wires. Designs are available which are suitable for temperatures up to 600F/315 C.

Materials of Construction:

Inert, inorganic fibers impregnated and bonded with epoxy resins

Temperature Range:

per ISO 2943)Note: 60C (140F) maximum for water based fluids

O - ring Code:

Multiply actual flow rate times factor in table below to determine pressure drop with fluid at 32 cSt (150 SUS),  0.9 S.G. Correct for other fluids by multiplying new viscosity in cSt/32 (SUS/150) x new S.G./0.9.  Note: factors are per 1000 L/min and per 1 US gpm.

Standard cartridges are capable of withstanding a collapse differential of 125

psid in the forward flow (outside-in) direction and up to 600 F and 10 psid in the

reverse flow direction

The standard series filters are cylindrical forms of pleated medium, 2 1⁄2inches in diameter in 10 inch multiple lengths, up to 30 inches.