Hydac HTMS series suction filter elements replacement

Specifications

HYDAC HTMS Series suction filter element

HYDAC HTMS Series tank mounted Suction Strainer Elements are designed for

installation into suction lines of pumps. Extra caution should be taken to ensure

that the suction elements are always mounted below the minimum oil level of the

reservoir.

Features

Standard models have nominal filtration ratings of 74 or 125 microns.The suction

strainer elements can also be supplied with a bypass valve to reduce high pressure

drops caused by contaminated elements or high viscosity fluids during cold starting.

The bypass valve opens at 3 psi. for best results, suction strainer elements should be

sized for clean element pressure drops of no higher than 0.5 to 0.7 psi. HYDAC suction

Strainer Elements are manufactured using stainless steel wire screen media.

Attention:

Suction strainer elements are only intended to protect hydraulic pumps against catastrophic

failure caused by coarse contaminants. Suction strainer elements should be inspected and

cleaned regularly. Suction strainer elements should not be used as the only filtration elements

in a hydraulic system. Pressure filters and return line filters, with reasonable dirt holding

capacity, must be installed to provide protection against component damage
caused by fine contaminants.