Wood Hammer Crusher
Negotiable /Piece
Min.Order:1 Piece
Zhengzhou Prominent Technology Co., Ltd.
The main parts of jaw crusher is fixed body frame, chassis manufacturing process, there are two: carbon steel casting of carbon steel welded steel frame and chassis. Welded frame is in the original cast of the rack on the addition of a number of ribs. According to the inlet width size into large, medium and small three, inlet width is greater than 600MM for large machines, inlet width in medium-sized machines, inlet 300-600MM a width of less than 300MM for small machine. of Wood Hammer Crusher
Structural condition of the jaw crusher: jaw crusher is mainly composed of a fixed body, rotating body parts, safety device, adjusting devices and other components Jaw crusher before starting bearing lubrication should be carefully examined the situation is good, whether the bearing bracket junction has enough grease
Features
Wood Hammer Crusher Long Service Life, High Crushing Ratio, Operate Easily,
Wood Hammer Crusher Operation Notes:
When crushed as a result of the crushing cavity material obstruction caused by parking, you should immediately turn off the power to stop running, will clean up after the crushing cavity material before re-starting.
Maintenance & Attention
Higher if the coarse crushed material (big discharge mouth size) of content or to mine the largest block to the mine mouth width ratio is large, the need to achieve crusher crushing ratio (broken before the material particle size and fragmentation than the diameter of the post material) is large, so reduced productivity; fine crushed material (close to or less than the size of the port of discharge) were more or less to the mine with the largest block to the mine mouth width ratio when implemented will have broken ratio is small, so the corresponding increase in productivity.
To Choose a Right Wood Hammer Crusher
Select comprehensive proposal cone crusher: 1, material handling hardness, hard broken, should choose multi-cylinder hydraulic cone crusher; 2, handle high abrasive, large water content material, should choose the speed cone crusher; 3, the processing of final products, especially thin material, should choose high-speed cone crusher; 4, treatment of soft material, should choose the bottom of single-cylinder hydraulic cone crusher, etc.