Specifications

Vertical Shaft Sand Making Machine Long Service Life, High Crushing Ratio, Large capacity, Can do Hard Stones, Mutiple Size,

Lubrication jaw crusher can often work and timely attention to ensure the normal operation of the friction surface and extend the life of the equipment. Add as 50-70%, the carrying capacity of oil must be replaced every three months, oil change, application of clean gasoline or kerosene carefully cleaned roller bearings. Bracket and bracket pad contact, before oil began to enter the crusher. of Vertical Shaft Sand Making Machine

In order to ensure good technical condition crusher equipment, ready to be put into operation, reduce downtime days, the fine crusher rate, utilization, reduce wear and extend the crusher, crusher to reduce operating and maintenance costs of living, ensure safe production crusher is to strengthen the routine maintenance work; do regular maintenance, mandatory Lubrication jaw crusher can often work and timely attention to ensure the normal operation of the friction surface and extend the life of the equipment. Add as 50-70%, the carrying capacity of oil must be replaced every three months, oil change, application of clean gasoline or kerosene carefully cleaned roller bearings. Bracket and bracket pad contact, before oil began to enter the crusher. Because of its simple structure, reliable operation, easy maintenance and repair, as well as low cost, present in our mines are widely used, basically use it to crushing hard and medium hard ore (rough broken and in pieces)

 

Features

Vertical Shaft Sand Making Machine Long Service Life, High Crushing Ratio, Large capacity, Can do Hard Stones, Life Time Support,

Vertical Shaft Sand Making Machine Operation Notes:

When crushed as a result of the crushing cavity material obstruction caused by parking, you should immediately turn off the power to stop running, will clean up after the crushing cavity material before re-starting.

 

Maintenance & Attention

Causes the upper crusher beating is uneven or give too much to mine ore. Causes the upper crusher is beating too ore containing small pieces and powder ore or humidity. Causes the upper crusher discharge mouth is beating the gap is too small

 

To Choose a Right Vertical Shaft Sand Making Machine

Select comprehensive proposal cone crusher: 1, material handling hardness, hard broken, should choose multi-cylinder hydraulic cone crusher; 2, handle high abrasive, large water content material, should choose the speed cone crusher; 3, the processing of final products, especially thin material, should choose high-speed cone crusher; 4, treatment of soft material, should choose the bottom of single-cylinder hydraulic cone crusher, etc.