Specifications

power amplifier
1:high power amplifier
2:audio power amplifier
3:switching power amplifier,DJ power amp
CE,RoHS,ISO9001,CCC

Power amplifier                   high power amplifier                  audio power amplifier                  professional power amplifier            switching power amplifier              dj power amplifier

Contact your sales representative Sawean Su at 0086 15018515829 always be here.

cn201432212

MT5500 Analog power Amplifier

Note: MT series powers all models of our loudspeakers , preferable for C-MARK AT-series loudspeaker or speaker array.MT1500 fits small size speakers, or drive of tweeter after scale down, making more pure and more rich sounds.

For extended periods of continual use of the amplifier, it is suggested that load impedance of each channel no less than 4Ω,and for bridged pattern, no less than 8Ω.

power amplifier Specifications

 

Output Power:
power input jack , fuse, voltage select switch
2Ω/per channel: 1200W
4Ω/per channel: 800W
8Ω/per channel: 550W
Bridged Output Power:
power input jack , fuse, voltage select switch
8Ω / bridged: 1600W
4Ω / bridged: 2000W

RMS Distortion: 
1KHz/8 Ω: 0.015%
1KHz/4 Ω: 0.030%
20Hz-20KHz/8 Ω: 0.150%
20Hz-20KHz/4 Ω: 0.200% 
Frequency Response:20Hz-20KHz 0.2 dB (8 Ω 1 W)
Damping Factor: > 200 under 8 Ω
S/N: >=110 dB
Slew Rate: 50V / μS
Voltage Gain: AV=85
Input Sensitivity: 0.775V under RMS output
Input Impedance:20 KΩ balance input 10KΩ under unbalance input
Controls & Indicators on Front Panel: AC power switch CH1 & CH2 Channel Gain Control
POWER LED: green LED × 2
SIGNAL LED: green LED -30B × 2 yellow LED -60B × 2
CLIP LED: red LED × 2
PROTECT LED: red LED × 2

Jacks and Controls on Back Panel 
Signal Input Jack: XLR balance input (1 ground 2 positive 3 negative)
Mode Selection: stereo. dual channel (parallel signal). bridged
Low Frequency Cut: minus 30Hz
Housing ground lift switch selected grounding: 
Output Jack: SPEAKON or post
Power: power input jack , fuse, voltage select switch
Cooling system. Two Φ80 fans auto speed high low adjustment according to temperature, thermostat set at 55 degreest. 
Amplifier Protection: short circuit protection, subsonic frequency protection, RF protection, clip protection, soft start equipment, overheat and voltage protection. 
Overload Protection: no thumps or pops are heard with turn-on /turn-off of speaker System overload automatic power-cut. Filter setting prevents peak overload of woofer. Limiting setting prevents high frequency clip wave and thus avoid teeter damage.
Output circuit types: efficient complementary linear output:
Power voltage: 100 V 120 V select switch, 220 V 240V select switch, 50Hz/60Hz, other voltage available if customized.
Dimension: 88mm × 483mm × 480mm
Weight: 26KG