Specifications

2 Ohm/per channel: 1500W
4 Ohm/per channel: 1100W
8 Ohm/per channel: 750W
8 Ohm / bridged: 2200W
4 Ohm / bridged: 3000W

C-MARK MT series powers all models of our loudspeakers, preferable for C-MARK AT-series loudspeaker or speaker array.

For extended periods of continual use of the amplifier, it is suggested that load impedance of each channel no less than 4Ω,and for bridged patttern,no less than 8Ω.

 

Specifications
Output Power:
power input jack , fuse, voltage select switch
2Ω/per channel: 1500W
4Ω/per channel: 1100W
8Ω/per channel: 750W

Bridged Output Power
power input jack , fuse, voltage select switch
8Ω / bridged: 2200W
4Ω / bridged: 3000W

RMS Distortion: 

1KHz/8 Ω: 0.015%
1KHz/4 Ω: 0.03%
20Hz-20KHz/8 Ω: 0.15%
20Hz-20KHz/4 Ω: 0.2%
Frequency Response: 20Hz-20KHz 0.2 dB (8 Ω 1 W)
Damping Factor: > 200 under 8 Ω
S/N: ≥110 dB
Slew Rate: 60V / μS
Voltage Gain: AV=98
Input Sensitivity: 0.775V under RMS output
Input Impedance: 20 KΩ balance input 10KΩ under unbalance input
Controls & Indicators on Front Panel: AC power switch CH1 & CH2 Channel Gain Control
POWER LED: green LED × 2
SIGNAL LED: green LED -30B × 2 yellow LED -60B × 2
CLIP LED: red LED × 2
PROTECT LED: red LED × 2

Jacks and Controls on Back Panel 
Signal Input Jack: XLR balance input (1 ground 2 positive 3 negative)
Mode Selection: stereo. dual channel (parallel signal). bridged
Low Frequency Cut: minus 30Hz

Housing ground lift switch selected grounding
Output Jack: SPEAKON or post
Power:power input jack , fuse, voltage select switch
Cooling system: Two Φ80 fans auto speed high low adjustment according to temperature, thermostat set at 55 degreest. 

Amplifier Protection: short circuit protection, subsonic frequency protection, RF protection, clip protection,soft start equipment,overheat and voltage protection. 
Overload Protection: no thumps or pops are heard with turn-on /turn-off of speaker System overload automatic power-cut.Filter setting prevents peak overload of woofer.Limiting setting prevents high frequency clip wave and thus avoid teeter damage.

Output circuit types: efficient complementary linear output
Power voltage: 100 V 120 V select switch, 220 V 240V select switch, 50Hz/60Hz, other voltage available if customised.
Dimension: 88mm × 483mm × 480mm
Weight: 36KG