Specifications

PT-JJ - 2  tissue homogenate machine

1. Use

Waring blender rotation speed is extremely high, at 12000 RPM, material in the glass by motor driven rotary knife simultaneously splitting, grinding, blending process, such as stirring up of material, the machine is small volume, low power consumption, high efficiency, but this machine is of high viscosity of the liquid and the material of hard physical properties (such as bone, etc.) are not appropriate.

2. The performance:

1. Scientific research: biochemistry, plant, such as nutrition research can use the machine pounded.

2. Medical treatment: laboratory and drug can be used, particularly suitable for group therapy drug dolly.

3. Chemical pharmaceutical: manufacturing gelatin emulsion and mixture of solid liquid substances, such as manufacturing oil agent harmonic, make beef liver stamp etc.

4. Biological manufactured goods: in the process of biological drugs manufacture, the liquid medicine and mixing of microbial culture medium stamp should be carried out under aseptic operation, the equipment must be strict disinfection, so as to avoid bacterial infection, the native structure both in aseptic operation requirements.

5. The food industry: it is used for manufacturing sauce, cheese, etc for stirring up.

3. The main parameters

1. Electric motor: vertical single-phase series motor

2. The rated power: 120 w

3. Working voltage: 220 v

4. Frequency: 50 hz

5. Speed: 0 - 8000 - 8000 RPM

4. Use method and matters needing attention

1. The first will cooperate good knife shaft and machine shaft, the connector after spring sexual yuan move down to the feet, groove (down the foot touch up with steps) machine operation.

2. Boot before, must pay attention to the power supply voltage is matched with the motor.

3. The carbon brush regularly to check, such as too short to replace the new carbon brush, such as carbon brush spark found abnormal should immediately stop using, check the obstacle reason, fix rear can use, in order to avoid the rectifier and the coil is burnt.

4. Due to the motor speed is high, such as continuous use can make the motor burn out, so time is limited to three minutes, 5 minutes off rear can use.

5. The glass is required for a device with the machine axis alignment, center, all without shake, to boot.

6. The machine should not be idle, must be put in a small amount of fluid or grease.

7. In the material must be slowly to join, to slow down, drive fast shift after, but a low gear can only be a starting role, shoulds not be commonly used.