Specifications
we have mult-color filaments.totally have 43 color.we have 1.75mm and 3mm filaments.
we have ABS and PLA and HSPS.
WANHAO PLA Typical Material & Application Properties | ||
| Film Properties | Ingeo 4032D | ASTM Method |
| Density | 1.24 g/cc | D1505 |
| Tensile Strength MD TD | 15 kpsi 21 kpsi | D882 D882 |
| Tensile Modulus MD TD | 500 kpsi 550 kpsi | D882 D882 |
| Elongation at Break MD TD | 180% 100% | D882 D882 |
| Elmendorf Tear MD TD | 17 g/mil 14 g/mil | D1922 D1922 |
| Spencer Impact | 2.5 joules | |
| Transmission Rates Oxygen Carbon Dioxide Water Vapor | 675 cc-mil/m2-24hr-atm 2,850 cc-mil/m2-24hr-atm 375 g-mil/m2-24hr-atm | D1434 Internal F1249 |
| Optical Characteristics Haze Gloss, 20º | 2.1% 90 | D1003 D1003 |
| Thermal Characteristics Melting Point | 155-170ºC | D3418 |
PLA
· More brittle than ABS
· Can droop if it gets too hot, for example, if it is left in a hot car in the summer time
· Usually turns white along the high stress zone when it is bent, then breaks into lots of little pieces
· Even though it is made from plants, it may contain dyes and binders which are not food safe
· Smells sweet when it is being printed
· Strength is relatively equal to ABS
ABS
· Impact resistant and tough
· Hard
· Glossy
· Petroleum based
· Flammable
· Prone to cracking if cooled too quickly
· Usually bends before it breaks
· Has a strong, toxic smell when it is being printed
· Strength is relatively equal to PLA