Specifications

we have mult-color filaments.totally have 43 color.
we have 1.75mm and 3mm filaments.
we have ABS and PLA and HSPS.

WANHAO   PLA                                                                   Typical Material & Application Properties
Film Properties	Ingeo 4032D	ASTM Method
Density	1.24 g/cc	D1505
Tensile Strength MD TD	15 kpsi 21 kpsi	D882 D882
Tensile Modulus MD TD	500 kpsi 550 kpsi	D882 D882
Elongation at Break MD TD	180% 100%	D882 D882
Elmendorf Tear MD TD	17 g/mil 14 g/mil	D1922 D1922
Spencer Impact	2.5 joules
Transmission Rates Oxygen Carbon Dioxide Water Vapor	675 cc-mil/m2-24hr-atm 2,850 cc-mil/m2-24hr-atm 375 g-mil/m2-24hr-atm	D1434 Internal F1249
Optical Characteristics Haze Gloss, 20º	2.1% 90	D1003 D1003
Thermal Characteristics Melting Point	155-170ºC	D3418

 

 

PLA

· More brittle than ABS

· Can droop if it gets too hot, for example, if it is left in a hot car in the summer time

· Usually turns white along the high stress zone when it is bent, then breaks into lots of little pieces

· Even though it is made from plants, it may contain dyes and binders which are not food safe

· Smells sweet when it is being printed

· Strength is relatively equal to ABS

ABS

· Impact resistant and tough

· Hard

· Glossy

· Petroleum based

· Flammable

· Prone to cracking if cooled too quickly

· Usually bends before it breaks

· Has a strong, toxic smell when it is being printed

· Strength is relatively equal to PLA