Product Details

High Capacity Bolts Joint Fiberglass GRP SMC Water Tank With Sealing Material

Product Description

SMC Water Tank Introudction

SMC water tanks are constructed of panels from SMC (Sheet Molding Compound) by

hydraulic hot press under high temperature and pressure conditions to maintain the best endurance.

Easy installation with bolts assembly on siteand tank shape and volume can be freely designed with

no restrictions based on site location, weather or climate.

SMC Water Tank Properties

SMC WATER TANK DESIGN PARAMETERS
Tensile Strength	≥70MPa
Flexural Strength	≥100MPa
bending modulus	≥7.0GPa
Barcol Hardness	≥60MPa
Water Absorption	≤1.0%
Fiberglass content	≥25 25%
Light transmission	Nil
Outdoor weathering(Natural sunlight)	Stabilized
Toxicity	Nil
Micro biological growth	Nil

SMC Water Tank Features

---No leakage after filled with water

---Easy to install in any size at site

---Safe for good grade and drinking water storage

---Easy to increase or decrease the size

---Resistant to corrosion, high strength

---Long service life

SMC Water Tank Assembly

Step 1. Install steel footings on leveled concrete foundations.
Step 2. Align GRP panels to be pre-assembled.
Step 3. Place rubber sealant from ready-to-use roll between panels.
Step 4. Connect panels with bolts and nuts.
Step 5. Position bottom panel sections, and finish up base of tank.
Step 6. Position three sides of the tank.
Step 7. Position and fix top panels and if required, top support pipes and plates.
Step 8. Install reinforcement if required.
Step 9. Close up the tank with the fourth side.
Step 10. Finish the internal or external reinforcement.
Step 11. Fill and test.