LAMP ourdoor commercial high resolution matrix led billboard
USD $1 - $8,000 /Set
Min.Order:1 Set
Shenzhen Lamp Technology Co., Ltd.
commercial high resolution matrix led billboard
features:
1, High brightness and be adjustable. Built-in functional card support brightness automatically adjustment.
2, a turn-key solution including professional sports software and hardware.
3, rich advertising LED display engineering experience both in domestic and oversea market.
4, Unbeatable product stability through strict Quality Control System.
specification:
Pixel Pitch: | 10 mm | 12 mm | 16 mm | 20 mm | 25 mm |
Pixel Density: | 10000 pixels/sqm | 6944 pixels/sqm | 3906 pixels/sqm | 2500 pixels/sqm | 1600 pixels/sqm |
Pixel Configuration: | 1R1G1B | 1R1G1B | 1R1G1B | 1R1G1B | 2R1G1B |
Module Dimension: | 160*160 mm | 192*192 mm | 256*128 mm | 320*160 mm | 200*200 mm |
Module Resolution: | 16*16 pixels | 16*16 pixels | 16*8 pixels | 16*8 pixels | 8*8 pixels |
Cabinets Dimension: | 640*640 mm | 768*768 mm | 1024*768 mm | 1280*960 mm | 1000*1000 mm |
Cabinets Resolution: | 64*64 pixels | 64*64 pixels | 64*48 pixels | 64*48 pixels | 40*40 pixels |
Brightness: | 6800 cd/sqm | 6800 cd/sqm | 7500 cd/sqm | 6000 cd/sqm | 5000 cd/sqm |
Best Viewing Distance: | > 10m | > 12m | > 16m | > 20m | > 25m |
Average Consumption: | 400 W/sqm | 350 W/sqm | 450 W/sqm | 320W/sqm | 264 W/sqm |
Max Consumption: | 800 W/sqm | 780 W/sqm | 900 W/sqm | 800 W/sqm | 550 W/sqm |
Viewing Angle: | Horizontal angle: 120 degree ;Vertical angle: 60 degree | ||||
Processing: | 12 bit | ||||
Ingress Protection: | Front IP65; Rear IP54 | ||||
Refresh Rate: | 300 to 4800Hz | ||||
LED lifetime: | 100,000 hours | ||||
Input Voltage: | 90 to 260VAC, 50/60Hz | ||||
Operation Humidity: | 10% to 99% |
system diagram:
LED display installation steps:
1. Assemble the cabinets on the structure.
2. Connect the UTP cables between cabinets.
3. Connect the AC cables between cabinets.
4. Install Sending Card.
5. Connect the DVI cable between Sending Card and Graphic Card.
6. Connect the COM cable between Sending card and computer.
7. Connect the UTP cables between Sending Card and Receiving Card.
8. Turn on control computer.
9. Install LED studio software (see attached CD and serial number is 888888)
10. Turn on LED display.
11. Set the display mode in “clone mode” in the window of Graphic Card properties.
12. Use the LED studio to control the display.