Specifications

480 TV lines car camera
mirror view and normal view switchable
waterproof test and shock test
170 degree
FCC certificate

1. Mirror view and normal view switchable
2. Complete water-proof lens, A grade chip sets
3. Following our execllent production technique and intensive QC control and test to ensure good quality.

1. Adopt digital high-resolution imaging process: 480TV lines
2. Extra-low illumination of 0.3 Lux for clear night vision
3. Automatic white balance function 
4. Viewing angle:170 degree
5. Water-proof,shock-proof and anti-jamming functions                                                        
6. Mini size: diameter:18.5mm, length:22mm
7. Pin nailed installation, hiding mounting

 

 

 

 

1. Wire Connection

When the camera is to be used for rear view with a monitor to assist with reversing.

 

 

2. Technology Data

 

Image device	1/4-inch colour
TV system	PAL or NTSC
Resolution	480 TV lines
Electric Shutter	PAL:625Lines.25Field /sec   NTSC :720Lines.25Field/sec
Effective pixels	PAL: 720X 576  NTSC: 720X 480
Minimum illumination	0.3Lux
Viewing angle	170 degrees (diagonal)
S/N ratio	>48dB (AGC-OFF)
Video output	RCA connector, 1.0vp-p, 75ohm
Current consumption	≤120mA
Power supply	DC8V-12V
Operating temperature	-30 to 65 degrees centigrade, RH95% Max.
Storage temperature	-35 to 70 degrees centigrade, RH95% Max.
Other items	automatic white balance, AGC and BLC
Water-proof	Yes, to IP68 standard

 

3. Mirror view and normal view is switchable  

 

 

Mirror view and normal view is switchable via a step switch on the power box.

 

Mirror view is switched on when delivery. You can switch it to normal view subject to your specific needs.

 

Mirror view is usually used for rear view while normal view is usually used for front view.

 

 

4. Camera Installation

 

 

 

A:Choose the proper position for screw holes and cable hole. Use a marker to mark points for the holes.

B:Use a good quality drill bit to drill the holes at the marked points.

C:Route the cable through the cable hole to the rear compartment and secure the camera with a screws. It is suggested to seal the holes with glass cement.