Best Cropping control Hot Metal Detector

Air & Water Specifications

Air Pressure: 1 cu ft./min at 5 PSI for normal conditions

                    5 cu ft./min at 15 PSI for severe conditions

Water Pressure: 5 to 10 PSI, 40 PSI Maximum

Water Volume: Regulate between 0.2 - 0.3 liters/min.

Water Temp.:

For Ambient Temperature up to 70°C use ambient water below 20°C

For Ambient Temperature up to 80°C use water chilled up to 10°C

Rear Bar Display

The rear bar display allows the user to clearly establish the amount of received IR both from the background metalwork and the bar being detected and thereby establishing the correct trip level required. This display also allows the user to align the Detector from a low energy source such as a flashlight, which normally would be insufficient to switch the Detector. Adjustment of both the threshold and the response time is also clearly defined by this bar.

Additional Information

To accommodate variation in bar temperature and background IR, various precise threshold are programmable via covered switches from 270°C to ensure reliable switching with reference to both the displayed background and product IR signal. Furthermore, response time is programmable from 1 ms to 250ms to accommodate black spots on the hot material.

The MSE-HMD85 Hot Metal Detector incorporates a remote self-check facility remotely energized by closed contacts that lights up an internal IR LED to switch the Detector and verify its’ outputs operate correctly.

The MSE-HMD85 Hot Metal Detector will operate with 80-240 VAC/50-60Hz or 24 VDC power input. Standard outputs include a cradle relay, a fast reed relay and both NPN/PNP transistor outputs.

General Specification