glue mixing machine
USD $1 - $2 /Set
Min.Order:1 Set
glue mixing machine:
Technical Parameters
Part One. Main technical parameters
1. coating mode: slot die
2. maximal coating width:350mm ,
coating weight:10-200gsm
3. machine speed: 50m/min
Glue tank capacity:lting speed:15kg/hour
4.equality:±0.003mm
5. roller length:400mm
6.Max. Dia. of rewind:400mm
7. Max. Dia. of unwind:400mm
8. unwind device:2 sets
9. rewind device:1 set
10.machine power:about 8kw
11.electrical power:380V ±15% 50Hz
12. Both speed of main machine and quantity of glue feeding are automatic synchronous tracking and manual control
Part Two: Introduction
(one) unwind device
1. one position unwind
2. Adopt one set of 12N·M magnetism brakes.
3.The pneumatic expanding shaft of unwinder 3″
(the core diameter:76mm)
(two) rewind device
1.One position rewind.
2.The rewind tension adopts a set of 12 N.M magnetism clutch
3.The pneumatic expanding shaft of unwinder 3″, the core diameter of paper tube is 76mm
4.The length of rewind can be changed manually or automatically
(three) coating compound parts
material of coating head: alloy steel
coating roller:130mm silica gel roller with two rotatable tie-in
cooling roller: 130mm steel roller plated chrome with two rotatable tie-in
compound roller;130mm steel roller two rotatable tie-in
compound pressure roller;130mm silica gel roller two rotatable tie-in
roller brace oneset
(four) driving parts
1.main electric power: 1.5kw,1set
2.The mainframe adopts isochronous cincture, chain and gear to drive
(five)gas controller
1. The coating head gas controller: 50mm, 1set
2. The compound roller gas controller: 40mm,1set
3. other pneumatic component: booster valve , manual valve
(six) electric parts
1.mainframe transducer:1.5kw 1pcs
2.transducer of glue tank:0.4kw 1pcs
3.temperature controller: several intelligent PID
4.several knob switch
(EIGHT) glue hose
1. material: Teflon
2. inner diameter:10mm
3. length:3000mm
4 .maximal pressure:60kg/cm2
5. maximal temperature:210°C
6. heating power: about 700w
(NINE) hot melt tank
The tank shell is jointed quadrate steel, groove steel and 1.2mm steel plate
The hot melt is founded of aluminum alloy , the inner layer is coated with antisticking Teflon layer.
Adopt built-in molten heater
The glue pump adopts metric gear pump that can bear high temperature
Collocate exact filter
The glue feeding pump adopts gear pump electric-motion frequency conversion to adjust speed
7.The temperature adopts PID controller.
8.The high temperature is 210°C
9.Heating power is about 3.5kw