Specifications
1.Rail pipe:Bosch2.High pressure pump:Bosch CP1
3.Secondary filter, 5um.
4.Windows XP
5.Touch screen
HY-CRI200A Common Rail Test Stand
The function of the tester for CR high pressure pumps is to provide the desired signal to drive the solenoid in the pump being tested.
The host transmission of the test bench uses frequency conversion; the pulse width and frequency of the injector drive signal is adjustable; short-circuit protection function; real-time measure the orbital pressure with high-pressure protection function; test six injector at the same time.
The pump /injector type can test: BOSCH-SIEMENS-DELPHI-DENSO
Functions
∞ Industrial computer with windows operating system;
∞ Having its own data base which can be queried, stored and modified to form a new data base;
∞ Adjustable common rail pressure in close-loop control, which is very stable with a fluctuation of ±1Mpa;
∞ Common rail pressure is displayed on the computer in real time;
∞ The driving signal, the pulse-width and the frequency is adjustable.
∞ Injection times and time can be set freely;
∞ Over voltage protection function--if the common rail pressure is over 1600bar the machine will stop by itself.
∞ Internet connection makes the remote control possible (optional);
∞ Safety shield of Plexiglass makes the operation very safe.
1.support carious rail pressure sensor
2.Protection function of short-circuit
3.The motor solt start,frequency-changing and speed regulation
4.Provide special fixture of testing injector
5.Pulse and frequency of the injector drive signal can be adjusted
6.Test the oil quantity of common rail injector
Function:
01.Measure the maximal permitted amount of the high pressure common rail injector
02.Measure the start-up oil amount of the high pressure common rail injector
03.Measure the oil return amount of the high pressure common rail injector
04.Test track pressure
05.Test fuel injection pressure of common rail injector
06.Test the spray cone angle of the common rail injector
07.Test the spray uniformity of the common rail injector
08.Test the tightness of the common rail pump
1.High pressure 0-2000bar
2. Check the injector starting pressure
3.Assessment of the injector spray fog quality
4. Inspeciton of the injector spray oil range
5.Check of the injector seal and angel
6.Check of the injector oil flow
7.The machine has fog dissipation convulsion device to improve the work condition.
8.It has the two garde filter to ensure the cleanliness of test.
9.The parameter of common rail injector ( fuel spray counts, frquency, pulse width, pressure etc