American standard pins, medium standard pins, European standard pins, made of H65 brass material, nickel plated on the surface, and the size can also be customized according to customer requirements.
USD $0.03 - $0.05 /Piece
Min.Order:10000 Pieces
Dongguan Licheng hardware electronics co., LTD
American standard pins, medium standard pins, European standard pins, made of H65 brass material, nickel plated on the surface, and the size can also be customized according to customer requirements.
1、 Copper material plug
Copper plugs are the most commonly used plugs because copper has good conductivity and corrosion resistance, making it an ideal material for making plugs. Copper plugs have a longer service life than plugs made of other materials and are less likely to cause short circuits. Meanwhile, copper has the characteristics of high strength and good plasticity, making it more convenient to use.
2、 Why do charger plugs need to be nickel plated?
1) Nickel plating on plugs refers to the process of plating a layer of nickel on the surface of the plug through a series of chemical and electrochemical reactions. This treatment can make the surface of the plug smoother, more wear-resistant, and more impedance, while the nickel plated layer also has good corrosion resistance and will not rust.
2) The main reason for nickel plating on plugs is that their surfaces are often exposed to damp and corrosive environments, such as in bathrooms, laboratories, and so on. These humid environments can cause the surface of the plug to rust, poor contact, increased resistance, and even short circuits. Therefore, the purpose of nickel plating is to protect the surface of the plug, increase its corrosion resistance, and extend its service life.
In addition, the unevenness and wear of the plug surface can also lead to poor contact and increased resistance. Therefore, nickel plating treatment can make the plug surface smoother and more wear-resistant, reduce the occurrence of these problems, and improve the quality of the joint.
Dongguan Licheng hardware electronics co., LTD., founded in 2010, our factory is located on approximately the dongjiang river, with Chinese electronic town -- shijie town, dongguan.
Our factory is specialized in production of metal stamping parts, high and low frequency transformer steel CLIP, spring CLIP (such as RM, ETD, EFD, EF, ER, EP, PQ, etc) and all kinds of electrical and electronic hardware parts, Brass terminal, lamp clip;copper needle, KAPTON film, etc. Its products are widely used in modern communication equipments, digital technology and household electrical appliances, etc.
To cater to today's era of science and technology, our factory has introduced advanced production equipment, testing equipment, has experienced r &d and technical personnel, and constantly improve the internal management level, scale, standardization, efficiency, innovation of management mode, to ensure efficient production, quality。