When the harvester is idle, dust, straw, seed bran and other debris should be cleaned as soon as possible, and then the whole machine should be rinsed with pressure water (belts, appliances, etc. must be removed and placed separately before cleaning), and dried. For metal parts (such as cutting parts), a layer of waste engine oil can be applied to the surface and a newspaper can be pasted for protection. The stripped parts should be repainted with the same color of paint

Store the harvester in a dry, ventilated, and hard ground, and support it with wooden supports near the tire frame. The four support points should be on the same horizontal plane to prevent deformation of the frame. It is advisable to support the tire at a height of 20-50 mm above the ground and release 2/3 of the gas inside the tire to prevent premature aging. Lower the harvester and cushion it with sleepers to fully retract the plunger rod of the hydraulic cylinder into the hydraulic cylinder, allowing the hydraulic pump to unload the load. Loosen the adjustment bolt of the header buffer spring to keep it in place.