Technical parameter | Value |
Input | Rated value | AC voltage: Single phase AC100V,400V Three phase AC100V,400V,660V(UL-L,Only72/96) AC current:AC1A,5A; DC voltage:1000V,300V,75mV,10V; DC current:0-20mA,4-20mA,5A; |
Overload | Voltage:1.2 times rated value(continuous); 2 times rated value/ 1 second Current:1.2 times rated value (continuous); 10 times rated value/1second |
Frequency | 45Hz~65Hz |
Power consumption | Power consumption of each voltage, current input circuit is less than 0.5VA |
Accuracy | 0.5 |
Function | Display | LED or LCD |
Communication | RS485,Modbus-RTU protocol;(1 start bit, 8 data bit, 1 stop bit, no parity) Baud Rate 2400/4800/9600/19200 bps etc. |
Alarm | 1 channel passive relay, contact capacity 3A/30VDC, 3A/250VAC, Used for high,low,unbalance alarmetc. |
Analog | DC4~20mA,(load<500Ω)(note:Shielded wire is specially selected for the above signal input and output) |
switching | Input | 4 channel or 2 channel dry contact Input, built in power supply |
Output | 2 channel switching output,NO relay contact, capacity:3A/30VDC,3A/250VAC |
Auxiliary supply | Voltage range | AC/DC85-265V |
Power consumption | <5VA |
Insulation resistance | >100MΩ |
Power frequency with stand voltage | Between power supply set of terminals and signal input, output set of terminals 2kV/1min (RMS) Between the shell and all set of terminals (except the set of terminals reference voltage less than40V) AC4kV |
Environment | Temperature | Operation:-10ºC~+55ºCStorage:-25°C~+70°C |
Humidity | ≤95%RH,no condensation,without corrosive gas |
Altitude | ≤2500m |