10006015 Acetic acid for laser cutting machine lens cleaning  Acetic acid 6% 100ml 10006015

It is important to note that acetic acid should be used with caution and only for lenses that are resistant to acid solutions. Always check the manufacturer's instructions before using acetic acid to clean lenses.

Here is a step-by-step guide on how to clean a laser cutter lens with acetic acid:
Make sure the laser cutter is turned off and unplugged before starting the cleaning process. This will prevent any accidental laser activation.
Mix equal parts distilled water and acetic acid (vinegar) to make a cleaning solution. It is best to use distilled water to avoid any mineral deposits on the lenses.’

Wet a clean lint-free cloth or lens cleaning paper towel with the prepared solution. Avoid using paper towels or rough materials that may scratch the lens.
Gently wipe the surface of the lens in a circular motion, starting at the center and moving outward. Be careful not to overexert or scrub too hard, as this can damage the lens.
If there are stubborn stains or debris on the contact lens, you can carefully remove them with a cotton swab dipped in cleaning solution. Again, be gentle to avoid scratching the lens.
After cleaning, use a separate clean cloth or paper towel to wipe the residual residue or moisture on the lens.

We offer a range of laser cutting machine accessories, including Acrylic Laser Cutter Parts ，Second Hand Equipment ， Cnc Bending Equipment ，Bystronic Glass tube ， Full range of nozzles Higher Qulity etc.