Product model:

ABB

61320954

Gray Encoder Board

ABB

61353372

protection card

ABB

63911500

Connection board

ABB

64250175

switch fuse

ABB

64581805

switch fuse

ABB

64787039

switch fuse

ABB

68262640

Main Circuit interface

Product series:

8VZZ001272K1100 SPC600VK01 Vertical, non-redundant

8VZZ001272K1101 SPC600VK01A Vertical, non-redundant

8VZZ001272K1200 SPC600VK02 Vertical, redundant

8VZZ001272K1201 SPC600VK02A Vertical, redundant

8VZZ001954K0100 SPC800K01 - Kit, non-redundant, horizontal

8VZZ001954K0101 SPC800K01A - Kit, non-red, horizontal, coated

8VZZ001954K0200 SPC800K02 - Kit, redundancy, level

8VZZ001954K0201 SPC800K02A - Kit, red, horizontal, coated

8VZZ001954K1100 SPC800VK01 - Kit, non-redundant, vertical

8VZZ001954K1101 SPC800VK01A - Kit, non-red, vertical, coated

8VZZ001954K1200 SPC800VK02 - Kit, redundant, vertical

8VZZ001954K1201 SPC800VK02A - Kit, red, vertical, coated

Product Description:

Measuring range ±10v /±5v / 0V / 0V

As differential input

Differential input is very useful if simulating the sensor

For remote non-isolation (e.g. negative end)

Far ground).

Because the ground potential is not exactly the same

AGND1, it must measure bipolar to compensate

Measurement error. In addition, in the case of unipolar

During the configuration, AGND1 is directly connected

To distant geodetic potential. This would have unacceptable consequences

(and potentially dangerous) ground loop.

Use two adjacent differential inputs in all configurations

Analog inputs belong together (e.g. e6000 and

Electronic Warfare 6 01).

The measured values were calculated by subtraction. the

Subtract the channel value from the lower address

The value from a channel with a higher address.

Converted measurements are occasionally available

Address, for example, e601.

It is important that:

The common-mode input voltage range is equal to the measured value

Single channel range. In other words, the signal,

Related to AGND, must not exceed the two related inputs

This measurement range.

The input voltage exceeds the measurement range

Overflow error message. If the measured value is below

Within this range, an underflow error message is generated