Injection molding machine special plastic dryer is mainly used for industrial plastic raw materials (such as PA, PC, PBT, PET, etc.) drying, most of the engineering plastic hygrhygability is very strong, if the raw material forming before the full drying treatment, it is easy to appear cracking, raw edge, bubbles, impact and poor viscosity and other defects, affecting the quality of the product, Therefore, it is necessary to use special plastic dehumidification dryer for injection molding machine.

Uniform distribution of hot air: High performance hot air diffusion device with uniformly distributed hot air can keep the plastic drying temperature uniform, increase drying efficiency and shorten drying time.

Reliability design: The equipment is strong and beautiful in appearance, easy to install, multiple safety devices to ensure work safety.

Double heat protection device: can reduce accidents caused by human or mechanical failure.

Refuse to burn clumps and buzz alarms above preset temperatures of 15°C

Intelligent temperature control: The use of high precision temperature regulator, can only control the temperature, the use of ratio deviation index temperature, eliminate the temperature error. Setting temperature and actual temperature double display overtemperature alarm device to ensure safe operation 24 hours automatic operation timing setting, and fault automatic display of power, plastic drying temperature rise (80-130) degrees.