What is Cooling tower fill?
305mm 610mm PVC honeycomb type corrugated PVC fills for cooling tower
While the reason for a cooling tower rotates around water, the genuine heart of any cooling tower is the cooling tower PVC fills.
COOLING TOWER PVC FILLS is a medium utilized as a part of cooling towers to build the surface region of the tower. Expanded surface territory considers most extreme contact between the air and the water, which takes into consideration more prominent dissipation rates.
The cooling tower fill gives a tremendously extended air-water interface for warming of the air and vanishing to occur. The water is cooled as it slides through the fill by gravity while in immediate contact with air that disregards it. The cooled water is then gathered in a frosty water bowl beneath the fill from which it is pumped again through the procedure to assimilate more high temperature.
Cooling tower fills of size 305 and 610mm made of corrugated virging quality PVC film duly vacuum formed and edge folded for extended service life. Available in black colors for cooling tower of counter flow type and cross flow type cooling tower. The edge folded technology will reduce the attrition loss of the fills and save the process equipment from fouling . extend the service life of pvc fills for yearsPVC Fills for Cooling Tower - We are one of the leading manufacturer & seller of PVC honeycomb type corrugated PVC fills for cooling tower.
Material | Width | Length | Pitch | Sample |
PVC/PP | 150mm, 305mm, 610mm, 915mm | 1000mm,1200mm, 1800mm,2400mm | 12mm/15mm/19mm | Free |
305mm 610mm PVC honeycomb type corrugated PVC fills for cooling tower
• Bevel Tips promotes drainage at fill pack interfaces. Note: Packs are always installed with Bevel Tips at bottom of pack.
• Patented "MA"(Mechanical Assembly) Technology for glue-free packs.
• Engineered microstructure for improved water distribution and thermal mixing
• High thermal performance
• Improved water distribution
• Proprietary edge trim that directs water to both sides of sheet
• Material meets Cooling Tower Institute (CTI) Standard 136
• Available in PVC
Cooling tower fill manufacturer
How shall we choose the PVC fill for the cooling tower
method,we advise to use the suitable thickness. If the width is less than 1.22meter, we advise to use the thickness less than 0.38mm; if the thickness is more than 1.22meter, such as 1.52meter, we advise the thickness should be more than 0.38mm. It is like apaper. If the width is very large, the thickness should be thick enough to bear the weight and strength.