10kA Surge Protector Lightning Protection Device 

 

 

 

 

Surge, also known as power surge, refers to the peak value that exceeds the stable value instantaneously, including surge voltage and surge current.

The surge in the power supply system mainly comes from two reasons: external (thunder and lightning) and internal (start and stop of electrical equipment, failures, etc.). Surge is often characterized by a very short time (the overvoltage caused by lightning is often in the microsecond level, and the overvoltage caused by electrical equipment is often in the millisecond level), but the instantaneous voltage and current are extremely large, which is very likely to affect the electrical equipment and Cables cause harm, so a surge protector is needed to protect them.

 

Surge Protector, English name Surge Protective Device, SPD for short, is an electronic device that provides safety protection for various electronic equipment, instruments and communication lines, and is mainly used to limit overvoltage and discharge surge current. Surge protectors are generally connected in parallel with the equipment to be protected. When an overvoltage is generated, it can have the effect of shunting and limiting voltage. Prevent excessive current and voltage from damaging the equipment.

 

 

 

   In addition to various commercial lighting power applications (ClassI, ClassII) such as street lighting, this product can also be used in security Surge protection for power ports of, electrical appliances, automatic control, medical treatment, precision machine tools, etc.

   TP10DB is aimed at the domestic market demand. The R&D team of Ruilongyuan Electronics independently developed a smaller size, higher cost performance, and better thermal stability.

 

Features of Surge Protector:

Small size, size 60×34.5×13.8mm

Nominal discharge current 5kA

The residual voltage is extremely low, less than 1.1kV

Common mode, differential mode full protection

With leakage current and freewheeling interruption function

Parallel installation wiring method

 

Surge protector application:

Single-phase meter

Electric vehicle AC charging pile

Street light power supply

LED Light power supply

Outdoor lighting/ Commercial Light 

LED outdoor large screen

Wall washer

Civilian single-phase power supply

Monitoring power supply

Various types of weak current control panels

Camera/ Refrigerator/ Air conditioner

Traffic Light/ Flood Light/ Tunnel Light/ Parking lot light/ Roadway light/ Digital Signage/ Security power supply 

 

Surge protector electrical parameters:

Rated working voltage: 277vac

Maximum continuous voltage: 277vac

Cross-sectional area (flexible): 1.3/16 square millimeter/awg

Installation: Custom

 

 

Surge protector increased parameters:

 

Note:
1. UVT: It is an abbreviation of Ultra low voltage triggering technology. It is a design that absorb the high and low voltage en
It can absorb the surge energy more completely, and the residual voltage is low, and the protection effect on the back
technology is patented by Ruilongyuan.
2. Class I: In this paper, a luminaire that refers to “accessible cond
IEC60598 - luminaires - general requirements and test
3. Class II: In this paper, the term “light-protection protection is not only dependent on basic insulati
double insulation or reinforced insulation, but no protective
Luminaires - General Requirements and Tests - Chinese
4. Leakage current: In this paper, the current flowing through the SPD does not occur when the power is connected. For example, zinc oxide vari
device with leakage characteristics.
5. Freewheeling: Current from the connected power source that
discharge tubes and thyristors are devices with freewheeling
6. 10kA: refers to the maximum discharge current (Imax) in the 8/20μs
7. 10kV: refers to the nominal discharge voltage (Vn) in the 1.2/50μs surge waveform test.

 

 

8/20μs Surge Waveform Test(RUILON laboratory):

 

 

Our Exhibition:

 

 

 

 

 

For more parameters, please call us~

 

 

Product Line: GDT, SPD, MOV, GGD, TVS, TSS, PTC, ESD, Spark Gaps.

 

For more preferential terms, please contact me actively. We promise to make you satisfied.

 

 

 

 

Ruilongyuan Electronics Co., Ltd. We are a manufacturer of electronic components in China, the brand is RUILON, the ex-factory price, and there is no middleman. New original, Price and quality are guaranteed. if you are interest, please contact us at any moment!

 

 Buy 100pcs Surge Protective Devices and give ONE away!!!!!