ANEN Power Product PA45 1 Pole 45A 600V Connector

 

 

 

Anen PA Series Power Connector provides cost-effective reliability, design flexibility and safety for your products' manufacture, installation and maintenance. The housings are modular and genderless. Anen PA connectors’ provide heavy duty reach 600 Volts continuous, AC or DC operation. Wire sizes range from 3/0 AWG 20 AWG. Contacts are available in reeled and loose piece designs to support all production needs from engineering prototype, low volume and high volumes products.

 

- Rated Current 45A

 - Rated Voltage 600V

- Fingger Proof

-Flat Wiping Contact System

-Interchangeable Genderless Design

 

PA45 Connector Parameter

 

 

Item	Value
Rated Current	45A
Rated Voltage	600V
Wire Size (AWG)	10-20 AWG
Contact Materal	Copper, Plated With Silver Or Tin
Insulation Material	PC
Flammability	UL94 V-0
Without Load, Contact/Disconnect Cycles	To 10,000
With Load (Hot Plug 250 Cycles & 120V)	20A
Average Contact Resistance (Mico - Ohms)	<500
Insulation Resistance	1000
Average Connection/ Disconnect (N)	15
Connector Holding Force (lbf)	150N Min
Environment Temperatures	-20···+75 Degree

 

 

PA45 Termianl Parameter

 

 

Item	Value	MOQ
PA261G2-T	10/14 AWG	2K/reel
PA261G1-T	12/16 AWG	2K/reel
PA262G1-T	16 & 20 AWG	2K/reel
PA1331-T	12/16 AWG	500 pcs
30/45BBS	N/A	500pcs

 

 

PA45 Connector Application

 

This safety quick connect/disconnect connector kits are widely applied in various field. This kits always are equipped in Electrical, folk lift, electric folk truck, golf car, tour bus and many other power-driven tools to solve the power-out problem. The terminal pins are made of red copper coated by silver, which has a strong electrical conductivity and can reduce the resistance to make the current and voltage stable. The mark of positive and negative are printed in the connector to avoid the miss plug. In the kit, a couple of boot caps are included to protect this quick connect and disconnect kits from the dust.

 

 

PA45 Connector Installation

 

1. Strip the insulation to fit the terminal pins.
2. Insert the cable into the terminal pins.
3. Crimp the terminal pins.
4. Insert terminal pins in housing with notched side of tongue next to spring.
5. Final adjustment Push contacts and cable into housing until the notched tongue snaps over end of spring; tug slightly to make sure contact is locked into place.