Product Description
Original genuine hollow electric encoder MBE 1024-3-TA 1024 pulse PLG TS5262N22 form on sale
Mitsubishi Spindle Encoder MBE1024-3-TA Installation Considerations
1. Before installing the encoder, check whether there is a deviation in the black head when the head is rotating. If the encoder is installed, the main shaft encoder will be erased after the encoder is installed. Therefore, check the table before the encoder is installed. The method is that a dial indicator is arranged on the black outer circle surface of the magnetic head, the main shaft is rotated by hand, Check the black outer round surface on the magnetic head for damage and no damage. . Use the air gun to blow clean the impurities at the installation .
2 Lightly set the spindle encoder Position the circle, and then use the flashlight from the side to see if the induction head inside the encoder and the magnetic head are in friction with the magnetic head. If you can't see clearly, you can use a piece of paper to check and see if there is a gap. If there is a gap, install the code. First, do not rotate the main shaft, and install the encoder. If there is a gap from the side, there should be a gap of 0.1-0.2 mm, and a piece of paper can be inserted into the gap, and the paper strip can be drawn back and forth. At the same time, the main shaft is slowly rotated by hand, and the paper strip will not be stuck and not stuck. If there is a gap, the paper strip can be removed, and the main shaft can be rotated slightly. Check whether the gap between the magnetic head and the induction head is uniform from the side, and if the gap between the magnetic head and the induction head is uniform, Even, the screw can be locked, the fan and the like can be installed, and the test is run again! It is easy to scratch round magnetic ring out of circle with special care when locking screw.
3. If it is not well installed, if you want to remove it, you can not pull it with your hand. Use a flat-line screwdriver to pry the three screw heads slightly on the outer side of the encoder. Remove the three screw heads by one-by-one, and may be scratched by hand. Head! Pay special attention to the induction head at the inner circle of the encoder, and the outer round surface of the black magnetic ring, as long as there is a bit of scratch, it may It's damaged. If the installation is damaged, you can't mention it.
4.Warranty! It's a special reminder, and it's best to have an experience. Pretend! I am not sure, can bring the motor encoder to our company, we provide free installation and debugging, but also can run motor testing.
More Products
certifications