MVP 280 bearing   Bearing stock in stock

Foute bearing stock model: 

K300 S-4792-A

K400 464973

S-4402-C 11D63

S-4401-C 10S46

S-4870-A 10S47

S-4400-C 10E18

S-4403-C 13S84

MVP280 09-95037

2416-1520 J-942-A

2416-4472 J-940-A

2410-0496 S-3756-C

548310-N12B

The bearing is the most important part of the jaw crusher, and it is easy to cause failure and damage the bearing under high temperature conditions. The following are the reasons and solutions for the excessive temperature of the jaw crusher bearing explained by Fute Heavy Industry.

1. Bearing wear or cage damage, etc.: Check the easy-to-wear parts of mechanical equipment in time, and replace the worn bearings.

2. Axial movement of the fixing bushing: remove the bearing cover on the frame, lock the fixing bushing and remove the flywheel or sheave, and replace the new fixing bushing.

3. The position of the flywheel counterweight of the crusher deviates, and the frame jumps: adjust the position of the flywheel counterweight to ensure that the position does not deviate.

4. The oil hole is blocked and the oil cannot be added: Clean the oil hole and oil tank blockage.

5. The bearing oil is cut off or the oil is injected too much: the user should read the manual carefully when the equipment is running, and refuel on time and quantitatively according to the instructions.

6. Non-bearing heating: it is caused by friction between the movable jaw sealing sleeve and the end cover, or the double-embedded cover of the frame bearing seat rotates with the main shaft, causing friction and heat. In this case, the end cover and sealing sleeve of the jaw crusher should be replaced, or the upper bearing cover on the heated end of the bearing seat of the frame should be loosened, and the fuse and the embedded cover should be pressed into the groove of the bearing seat of the frame, and then the bearing should be set. cover, to eliminate the inset cover rotation.

Liaocheng Fute Bearing Technology Co., Ltd.

Phone  : 0635-2855567

Mobile : 13561491333

Email  : futezc@163.com