Advantage:
1) completely prevent the water tank to be rusted, you can use it up to 70 years: the box module is one-time molding and stretching,No welds,build up with bolt,Avoid intergranular corrosion which occur After welding and stress corrosion

2) After detection of Southeast University,Structure fully meet the "building and equipment seismic design specifications" seismic requirements,Seismic rating are 6,7 ,8,9 degree.

3) Health: all parts made up with SUS30408 health stainless steel material which Immersion in water;

4) energy saving:
Saving labor - compared to the original welding tanks can reduce about 50% duration , such as: 50m3 tank normally need 10 normal individuals to welding ,The SW tank only need five individual workers;
Saving energy- entire assembly process does not require welding,can save 99% energy compare with welding tank.
Saving material- inside the SW water tank without Stretch,can save 30% material compare with welding tank.
Environmental: Compared with welding tank,our products can Secondary disassembly and recycling.

5) high strength: The strength are better than or equal 235 steel, molded by the convex arc coupled with an X-shaped, strength are more than 3 times of convex arc.

6) Long life, cost-effective: for example, with the same volume tank,price is same.Welding tank's life ended up to 10 years for the rust corrosion,But ours is more than 70 years.So you saved alots of money.

7) Easy to clean:without internal reinforcement,safe for worker,Easy to cleaning,And safe for labour.
Scope: suitable for life cold&hot water tank, fire water tank, underground water tanks.

Stainless steel water tank specification
Raw material	stainless steel sheet  SS304-2B, SS316L
Panel size	1000*1000, 1000*500, 500*500
Panel thickness	1.5mm, 2mm, 2.5mm, 3mm, 4mm
Process technique	Ramming craft
Accessories	Tiepiece, support, flange/socket, ladder, angle iron, water gauge,welding stick
Foundation	Concrete foundation and U-steel bottom base
Connection type	Argon arc welding
Working time	more than 10 years

 

SMC/FRP/GRP water storage tank Advantage:
1) Light weight, high strength.
2) Leak-proof /Water Tightness: Due to the material is fiberglass reinforce plastic with high density, and the sealing tape is high performance with non toxic, so it's leak-proof tank;
3) Long lifetime, long durable time: the maximum distortion of the sidewall is less than 1 percent for the height; maximum distortion of the bottom center is less than 10mm. The normal durable lifetime is more than 30 years.
4) Corrosion resisting; anti-rusted
5.Easy to clean and maintenance management convenient, Drainage at the tank bottom can be cleaned easily and Manhole panel makes it easy to enter into the water tank inside.
6) Non-toxic, it is made from food grade resin, clean and no pollution. SMC Water Tanks satisfy relevant Food Sanitation standards. Since exterior light is completely blocked, bacteria generation and germ growths are prevented.

 

Step 1. Install steel footings on leveld concrete foundations.
Step 2. Align GRP panel to be pre-assembled.
Step 3. Place rubber sealant from ready-to-use roll between panels.
Step 4. Conect panels with bolts and nuts.
Step 5. Position bottom panel sections,and finish up base of tank .
Step 6. Position three sides of the tank .
Step 7: Position and fix roof panels and if required ,roof support pipes and plates.
Step 8: Install reinforcement if required.
Step 9: Close up the tank with the fourth side .
Step 10.Finish the internal or external reinforcement .
Step 11.fill and test .