B+RS400/F65H bus protocol electric actuator

SD series electric actuator can be divided into three adjustment modes:

A integral proportion control type, that is, the actuator and position locator GANo-2007 (commonly known as square) assembled into a whole (also known as electronic)

The whole machine is installed and used on site.

B. Separate proportional control type, the actuator is also composed of the actuator and position positioner, but the actuator and position positioner GAMNX are separated

The actuator part is installed on site and the position locator is installed indoors or elsewhere. Position locator appearance, use, safety

There are detailed instructions for loading samples. Note: Integral and separate external connections are different.

(2) Optional control actuator receives switching signal or relay signal, the output shaft of the actuator can be controlled in any position.

(3) Switch type is also known as two type, it receives switch signal, the output shaft of the actuator can only be controlled in the open and close two limit positions.

(4) The integral adjusting actuator receives the pulse signal, and adjusts the parameters according to the width of the pulse or the width of the pulse number. discrete

The type proportional control electric actuator is actually a remote control with a separate GAMX positioner

Here in particular: no matter the Angle stroke, straight stroke, multi-turn electric actuator its circuit principle, external wiring, adjustment methods are the same

, you should pay more attention to the power supply, voltage, installation mode, output torque, stroke, signal meet your requirements when selecting the type of use.