We usually use nozzle on machines,always face problems,so what can we do and in case them don't happen again?

Here Let's see NPM CM panasonic machine nozzle,Top 6 Daily Maintenance Manuals

1, surface of the SMT nozzle is cleaned with a dust-free cloth;

2, Separate and soak the nozzle and holder，Small aperture nozzle can be opened with a thin steel wire, blowing it to pass;

3, the surface of the nozzle can not be soaked with corrosive solution such as alcohol, otherwise the surface will fall off;

4, HOLDER wipe the cavity with a cotton swab, do not smash the filter;

5, HOLDER minions regularly add special grease;

6, according to the production * good regular maintenance, usually do other maintenance

Below we will give an example to explain the nozzle of the following machine,

 Model: Panasonic CM602/CM212 nozzle NOZZLE is maintained in series order:

  1, the needle cleans the nozzle rod;

  2, wipe the reflector;

  3, check the nozzle rod for deformation

  4. Blow the nozzle rod.

  5, load the machine to check the vacuum value is CM602 less than -85 is OK. CM212 is less than -65 is OK.

The MSH3 nozzle operates as follows:

  1. Soak the nozzle into the alcohol box for about 10 minutes.

  2, clean the nozzle rod with a needle

  3, blowing the nozzle rod

  4. Visually check that there is no blockage in the nozzle rod.

FS specialized in electronics manufacturing industry and Provide full SMT line solution,Help you achive industrial 4.0.