The MiniProg4 Program and Debug Kit is an all-in-one development programmer and debugger for PSoC® 4, PSoC 5LP, and PSoC 6 MCU devices. Use MiniProg4 as a programmer or debug probe for supported Cypress devices. and development kits, like the PSoC 6 WiFi-BT Pioneer Kit.

MiniProg4 uses the industry standard CMSIS-DAP interface over Serial Wire Debug (SWD) protocol. It uses CMSIS-DAP V2.0.0 and V1.2.0 as the bulk and HID endpoints transport mechanisms. MiniProg4 implements USB bulk endpoints for faster communication. It also supports HID endpoints for use cases that require them, but communication is slower. Out of the box, MiniProg4 uses bulk endpoints.

MiniProg4 also provides USB-I2C, USB-SPI and USB-UART bridging functionality. MiniProg4 bridging capabilities are used by tools like CapSense. Tuner and the Device Firmware Upgrade Tool, delivered with ModusToolbox™ IDE. MiniProg4 support PSoC Creator, PSoC Programmer, and the Bridge Control Panel is planned.

Ecosystem

• ModusToolbox IDE

• Cypress Programmer 2.0

• Development Kits
  

• PSoC 6 MCU Kits

• PSoC 5 Kits

• PSoC 4 Kits

If you need a program/debug kit for PSoC 1 or PSoC 3 devices, see the MiniProg3 web page.

Interfaces

Connector	SWD	I2C	SPI	UART (With and Without Flow Control)
5-pin	Yes	N/A	N/A	N/A
10-pin	Yes	N/A	N/A	N/A
6x2 header	N/A	Yes	Yes	Yes

Kit Contents

The CY8CKIT-005 PSoC® MiniProg4 Program and Debug Kit includes:

• MiniProg4 programmer/debugger

• 10-pin ribbon cable

• USB Type-A to Type-C Cable

•