Introduction of Nut Chopping Machine

1.The peanut cutting machine is mainly used in food processing industry : beans, nuts (such as peanuts, almonds, walnut, hazelnut, chestnut) different particle size materials chopped.

2.It consists of three sections of feeding, chopping and classification which vibration feeding section can enable the peanuts to evenly fall into the container where the peanuts are being evenly chopped by rolling knives, in the classification section sieves of different sizes are installed which the peanuts into different sizes. By changing working speed of feeding conveyor to adjust the size of finished peanut particle.

3.Material through the hopper discharge uniformly, sent by the conveyor belt into the shredding bodies chopped, material crushed by vibration grading to get requirement particles. The reciprocating speed of the cutte i constant by changing the rotational speed of the conveyor belt, namely increase the number of shearing material received, so as to achieve the purpose of adjusting the particle size.

Advantage of Macadamia Nut Chopping Machine

1. The properties to this machine are high production, equal size, low material consumption, low noise and no oil from the chopped peanuts.

2.Multifunctional machine, not can process beans but also can process peanuts, almonds, walnut, hazelnut, chestnut and so on nuts.

3.The chopping blades cut the materials at certain speed, by adjusting the speed of conveyor, the materials would be chopped into different sizes.

4. The chopped particles are selected through the vibrating screen.

5.Equipped with vibration screen, can grade the chopped granules into different levels. And the size of the mesh screen is custom-made.

6.Chopped evenly, with little powder, no oil squeezed out.

Main Features

1.Peanut will be sent into machine with conveyor.

2. The working speed of cutter is constant .

3.The finished pieces sizes can be adjustable.

4.the machine is made of stainless steel.

FAQ

1. Does the material should be peeled?

As your demand.

2. What about the cutting size range?

Normally 2-10mm, minimum 2-5mm.

3. What is the tool holder structure and material?

Each machine is arranged with 10 cutting knives side by side, reciprocating and chopping up and down, blade size: 54cm*6cm*3mm, material 4Cr13

4. What is the water content requirement?

When the moisture content of the material is controlled at 4%-5%, the chopping effect is best.

5. How about the output?

When the particle size is 2-3 mm, the output is 100-150 kg. If the particle size is more than 5 mm, the output is 200-300 kg.

Mobile WhatsApp:+8618638675956

Email: Silvia@machinehall.com

/