Motor type	Output Power	Voltage	Load	Speed	Rated Torque	Efficiency	Noise	IP Class
	KW	V	A	RPM	Nm	%	dB
VOL- IEC90S2250-2P	2.25	220 ac	6.42	3000	7.16	92	62	IP 54
VOL- IEC100S2250-4P	2.25	220 ac	6.42	1500	14.33	92	62	IP 54
VOL- IEC112S2250-6P	2.25	220 ac	6.42	1000	21.48	92	62	IP 54
VOL- IEC112S3750-2P	3.75	220 ac	10.70	3000	11.94	92.5	62	IP 54
VOL- IEC112S3750-4P	3.75	220 ac	10.70	1500	23.88	92.5	62	IP 54

 

VIEW MORE PLS CONTACT US >>>

 

 

 

 

Q:Motor has been running then fails to start,what to do?
A:Likely cause: Fuse or circuit breaker is tripped. 

      What to do: Replace the fuse or reset the breaker.

 

     Likely cause: Armature is shorted. Motor may make a humming noise and the circuit breaker or fuse will trip.
     What to do: Disassemble motor and inspect the armature for a burnt coil. Inspect the commutator for burnt bars. If this condition exists, the motor needs to be replaced.

 

     Likely cause: The brushes may be worn down too far and no longer make contact with the commutator.
     What to do: Check the brushes to make sure that they are still making contact with the commutator. Contact manufacturer for brushes.

 

      Likely cause: Controller may be defective.
      What to do: Verify voltage is coming out of the controller.

 

Q: On initial installation, motor fails to start up,what to do?
A: Likely cause: Motor is incorrectly wired
     What to do: Verify that the motor is wired correctly.

 

     Likely cause: No output power from controller.
     What to do: Measure voltage coming from the controller.

 

     Likely cause: Motor is damaged and the armature is rubbing against the magnets.
     What to do: Disassemble motor and see if the armature can be realigned by reassembly. Motor may have to be replaced.

 

Q:  Motor takes too long to accelerate,what to do?
A:  Likely cause: Motor controller not properly set.
     What to do: Adjust the acceleration trim pot of the controller.

 

     Likely cause: Brushes are worn.
     What to do: Verify brush length.

 

     Likely cause: Bearings may be defective.
     What to do: Inspect bearings. Noisy or rough bearings should be replaced.

 

Q:  Motor runs in the wrong direction,what to do?
A:  Likely cause: Incorrect wiring
     What to do: Interchange the two motor leads.

 

Q:  Motor runs OK but has a clicking noise,what to do?
A:  Likely cause: Suspect a burr on the commutator.
     What to do: Remove burr from commutator using a commutator stone.