Motor type	Output	Voltage	Load	Speed	Rated Torque	Efficiency
	KW	V	A	RPM	N.m	%
BLDC1.55-154	1.55	45	40	4300	3.44	86
BLDC1.8-154	1.8	60	32.6	1100	15.6	92
BLDC1.85-154	1.85	24	81.5	2100	8.41	92
BLDC2.7-154	2.7	60	48.9	1100	23.4	92
BLDC2.8-154	2.8	60	50.8	1100	24.3	92
BLDC2.8B-154	2.8	48	67.8	2600	10.3	86
BLDC3.0-154	3.0	48	67.6	2650	10.81	92.5
BLDC3.0B-154	3.0	72	46.8	1850	15.5	89
BLDC3.5B-154	3.5	60	69.5	1680	19.9	84
BLDC4.0-154	4.0	48	90.6	2580	14.81	92
BLDC5.5-154	5.5	72	85.6	3680	14.27	89.2

 

 

 

VIEW MORE PLS CONTACT US >>>

 

 

 

 

Q:Motor has been running then fails to start,what to do?
A:Likely cause: Fuse or circuit breaker is tripped. 

      What to do: Replace the fuse or reset the breaker.

 

     Likely cause: Armature is shorted. Motor may make a humming noise and the circuit breaker or fuse will trip.
     What to do: Disassemble motor and inspect the armature for a burnt coil. Inspect the commutator for burnt bars. If this condition exists, the motor needs to be replaced.

 

     Likely cause: The brushes may be worn down too far and no longer make contact with the commutator.
     What to do: Check the brushes to make sure that they are still making contact with the commutator. Contact manufacturer for brushes.

 

      Likely cause: Controller may be defective.
      What to do: Verify voltage is coming out of the controller.

 

Q: On initial installation, motor fails to start up,what to do?
A: Likely cause: Motor is incorrectly wired
     What to do: Verify that the motor is wired correctly.

 

     Likely cause: No output power from controller.
     What to do: Measure voltage coming from the controller.

 

     Likely cause: Motor is damaged and the armature is rubbing against the magnets.
     What to do: Disassemble motor and see if the armature can be realigned by reassembly. Motor may have to be replaced.

 

Q:  Motor takes too long to accelerate,what to do?
A:  Likely cause: Motor controller not properly set.
     What to do: Adjust the acceleration trim pot of the controller.

 

     Likely cause: Brushes are worn.
     What to do: Verify brush length.

 

     Likely cause: Bearings may be defective.
     What to do: Inspect bearings. Noisy or rough bearings should be replaced.

 

Q:  Motor runs in the wrong direction,what to do?
A:  Likely cause: Incorrect wiring
     What to do: Interchange the two motor leads.

 

Q:  Motor runs OK but has a clicking noise,what to do?
A:  Likely cause: Suspect a burr on the commutator.
     What to do: Remove burr from commutator using a commutator stone.