3. Technical parameters

4. Configuration

Installation notes: this module is applicable to 35mm track installation. You just need to clamp the module into the track for installation.

5. Electric wiring diagram

1 Mains input terminal

2 Relay manual operation hole

3 Programming key

4 KNX bus terminal

5 Running and programming indicator

6 Label

7 0-10V dimming signal output

8 0-10V diming power supply

6. Application guide

0-10V dimming driver controls the load on-off as the diming module and outputs 0-10V dimming signals. The dimmer receives the control message from the bus and then executes the corresponding actions according to the set parameters. With ETS programming, the dimmer can realize multiple control functions. The high voltage line is not changed and the lighting control is changed.

The functions of the dimming driver are shown below:

 Switch function: manual operation control included

 Dimming function: relative dimming and value dimming function

 Preset function

 Scene control

6.1 Product features

The dimming driver is the execution unit. The maximum load current of each circuit of relay of the dimmer is 16A. The load may be capacitive, resistive or sensible. The dimmer can communicate with any module in accordance with KNX standard. The sensor sends the control message, the dimmer receives and parses the message and then executes the relevant action. The dimmer has multiple functions and the specific functions need to be set with ETS software

6.2 Operating guide

1. Connect the module with the engineering network and connect the communication network with the computer attached with ETS by USB or IP gateway. Check whether the communication between the computer and network is normal.

2. Import VD3 file into ETS database and establish the relevant project. Add the dry contact module in the topological structure and set its physical address (the physical address cannot be repeated); later, open the parameter configuration page of the dry contact module and configure the corresponding parameters; finally, set the corresponding group address according to the actual needs.

3. Click the download options in ETS, press the programming button of the dry contact module, and then download the parameter configuration information to the module. Finally, finish the application programming

6.3 Parameter description

The dimmer parameters are used to set all dimmer parameters. The parameters include each channel of channels and the specific execution action of the corresponding function. The module has 2 circuits and 4 circuits. All circuits of functions and parameters are same. Thus, take Channel 1 in the parameter description in the manual for example. For other channels’setting, refer to Channel 1.