1. INTRODUCTION

1.1 BASIC SAFETY INFORMATION

IMPORTANT!

 Dangers, Warnings, and Cautions alert you to important

operating instructions or to potentially hazardous

situations. Pay special attention to these items.

 THIS IS NOT A SMOKE ALARM! This CO Alarm is

designed to detect carbon monoxide from ANY source

of combustion. It is NOT designed to detect smoke, fire,

or any other gas.

 This CO Alarm is approved for use in single-family

residences. It is NOT designed for marine use.

! CAUTION!

 This CO Alarm will only indicate the presence of carbon

monoxide gas at the sensor. Carbon monoxide gas

may be present in other areas.

! WARNING!

 The Silence Feature is for your convenience only and

will not correct a CO problem. Always check your home

for a potential problem after any alarm. Failure to do so

can result in injury or death.

 This CO Alarm cannot operate without continuous

electricity. It does not operate during a power failure.

 NEVER ignore your Carbon Monoxide Alarm if it alarms.

Failure to do so can result in injury or death.

 Test the CO Alarm once a week. If the CO Alarm ever

fails to test correctly, have it replaced immediately! If

the CO Alarm is not working properly, it cannot alert you

to a problem.

 This product is intended for use in ordinary indoor

locations of family living units. It is not designed to

measure CO levels in compliance with Occupational

Safety and Health Administration (OSHA) commercial

or industrial standards. Individuals with medical

conditions that may make them more sensitive to

carbon monoxide may consider using warning devices

which provide audible and visual signals for carbon

monoxide concentrations under 30 ppm. For additional

information on carbon monoxide and your medical

condition contact your physician.

1.2 HOW YOUR CO ALARM WORKS

GENERAL INFORMATION

CAUTION!

Leave your CO Alarm powered in year-round. CO problems

can occur any time during the year, and this Alarm can only

alert you if it is plugged in and receiving power.

This CO Alarm is intended for use in a standard AC220V

power supply. It is not intended for use in extension cords,

power strips, or outlets controlled by a switch or dimmer.

These may not provide continuous power to the unit.

When fully powered, it samples the air and takes a new

reading about every second. A microchip inside the unit

stores each reading, and remembers the levels of CO it has

been exposed to over time. The unit goes into alarm mode

when it has been exposed to a “critical” level of CO

(measured in parts per million or “ppm”) within a specified

time (measured in minutes).

This Carbon Monoxide Alarm features a permanently

installed sensor, three colored indicator lights, and an 85dB

alarm horn. It also has a Silence Feature to temporarily quiet

the alarm horn.

2. FEATURES

 Detect carbon monoxide.

 High quality durable electrochemistry sensor for CO

gas detection.

 Easy to install.

 Loud 80dB alarm and LED warning light.

 Self diagnostic function by MCU intelligent software.

 Excellent reliability & High stability.

 Ideal for all house and kitchens.

3. TECHNICAL SPECIFICATIONS

Unit Dimensions: 122mm (H) x 76 mm (W) x 38mm (D)

Color: Ceiling White

Operating Temperature: -10°C to +50°C

Ambient Humidity: ≤95% RH

Alarm Horn: 80dB

Operating Voltage: AC220V/50HZ

Power Consumption:<1.5W (Standby), <3W (Alarm)

Value of Detection Threshold (Lower Explosive Limit):

CO Gas: >150ppm (Alarm in 1 to 3 minutes)

Sensor lifetime: > 3 years

Alarm: Red LED with 80dB alarm

Warm Up Time: approximately 60 Seconds

Alarm Output: Voltage Output (DC12V pulse or steady)

(Only for Control Module)