VDE 0470 part 2 picture 8 probe 12 Cylinder Test Pin iec 61032 test pin

VDE 0470 part 2 picture 8 probe 12 Cylinder Test Pin

iec 61032 test pin

IEC61032  Long Test Pin (test probe 12) for safety testing

Article NO.:BND-12

in accordance with VDE 0470 part 2 picture 8 probe 12 resp. IEC/EN 61032
Additional standards: IEC/EN 60950 and IEC 60035
Access- and object probe for the detection of protection of persons against access to dangerous, active parts and
also against the accidental access with a tool e.g. screwdriver or with a similarly sharp object.
The cylinder test pin Ø 4 mm is 50 mm long. It is made of high-grade steel and enclosed in a plastic holder.
There is a 4 mm receptacle conductively connected to the probe for contact- and continuity checks.

Technical parameters

1, The probe Diameter :4mm

2, The probe Length:50mm

3,Dam- board Diameter:25mm

4, Dam- board Length:4mm

5,Reference Standard: IEC61032:1997 in figure 8

Appliance:

This pin is intended to be used on appliances for verifying the inaccessibility of hazardous live parts or hazardous mechanical parts which are liable to be touched accidentally by a tool, for example a screwdriver or similar pointed object in normal use.The handle dimensions (Ø 10 and 20) are not critical.

NOTE The test pin dimensions are those given in Figure 9, test probe 13 of IEC 61032. In some cases the tolerances are different.