IPX3 IPX4 water spray nozzle/brass water spray nozzle

IPX3 IPX4 water spray nozzle/brass water spray nozzle

 

 

 

Introduction:

 

 

The Spray Tester IPX 3/4 is a hand-held test device to verify protection against spraying and splashing water. The water pressure can be adjusted using the flow control knob on the device to give the required flow rate. The pressure can be seen on the gauge which is convenient positioned by the Spray Tester IPX 3/4.The spray pattern of the nozzle is made to the specifications of IE60529. The removable shield feature make it easy to test without the interference of the shield .

 

 

Applications:

 

Spray Tester IPX 3/4 is designed to perform tests in large and small scale products. It is a great option when a portable tester is necessary. The  Spray Tester IPX 3/4 is an alternative to the Oscillating Tube for establishing the degree of protection against ingress water.

 

The Spray Tester IPX 3/4is intended for use on specimens that will not fit within the diameter of the Tube Tester. The primary IEC tests include IPX3 and IPX4 protection against water spraying and splashing water.

 

 

No.	Item	parameter
1	Water supply	Water flow rate is 50~150kpa clean water without inclusion.
2	Spray nozzle parameters	external diameter: 102mM spherical diameter: S 75.5mm There is a middle hole and There are 24 holes in the internal circle of holes of which the included angle is   30°. There are 96 holes in the external circle of holes of which the included angle is 15°.
3	Water flow	10L/min±5%,Flow meter is adjustable
4	Range of pressure gauge	0~0.4Mpa
5	Baffle	removable
6	Pressure gauge	0~0.25MPa
7	Site requirements	Dedicated IP waterproof test room,The ground should be flat with illumination With good function of inflow and drainage. Wall installation

 

Number of Holes	121
Diameter of Nozzle Holes	0.5mm
Material	Spray nozzle make of brass
Reference	IEC60529, IEC60598-1, IEC 60335-1, IEC60745-1