Product Details

Technical parameters and requirements of the first and second stages of the winding rubber track vulcanizer

1、 Main technical parameters of winding rubber track vulcanizer:

1) Maximum clamping pressure ofrubber tracks vulcanizer: 160 tons

2) Maximum closing pressure of rubber tracks vulcanizer hot plate: 300 n / cm2

3) Inside diameter of mould locking cylinder (four) of vulcanizer: 190mm

4) Diameter of piston rod of mould locking cylinder (four) of vulcanizer: 90mm

5) Size of upper and lower hot plate of vulcanizer (L * w * h) 950mm * 600mm * 80mm

6) Hot plate size of first and second stage rubber tracks vulcanizers:

NO.	Length（mm）	Width（mm）	thickness（mm）	Splicing plates	remarks
Medium heat plate	950	600	80	2*100	first stage vulcanizer
Medium heat plate	950	600	80	2*100	Second stage vulcanizer
Upper and lower hot plate	950	600	80	2*100

7) Distance between hot plates in upper hot plate: 540mm

8) Distance between intermediate and lower plates: 540mm

9) Upper hot plate stroke: 440mm

10) Lower hot plate stroke: 440mm

11) Distance from the upper surface of the medium heat plate to the ground: 1000mm

12) Minimum die thickness: 100 mm

13) The hydraulic system of the rubber tracks vulcanizer should have the function of pressurization and pressure relief. When the mold locking pressure increases to 110% of the set pressure, the pressure will be released until the set pressure is released.

14) The effective displacement distance of the tensioning wheel on both sides of the plate is 500mm.