Deep Sea Generator Control Unit Automatic Start Control Panel DSE4110

• Manual start
• Automatic start
• Engine pre-heat
• Engine monitoring and protection features
• Protected Solid State (PSS) outputs
• Front panel mounting
• Front panel programming

• Tamper proof engine hours counter
• Remote start
• LED indicators
• Configurable inputs
• Configurable timers
• Configurable outputs
• Engine exercise mode

Key Benefits
• On-site module configuration to match user requirements
• Hours counter provides accurate information for monitoring warranty periods
• Multiple engine parameters are monitored simultaneously

Specification

DC SUPPLY

CONTINUOUS VOLTAGE RATING
8V to 35V continuous

CRANKING DROPOUTS
Able to survive 0V for 50mS, Providing supply was at least 10V before dropout and supply recovers to 5V. This is achieved without the need for internal batteries.

MAXIMUM OPERATING CURRENT
150mA(12V), 250mA(24V)

TYPICAL CURRENT
20mA(12V and 24V)

CHARGE FAIL
8 Volt Charge Fail at 12 Volts,
16 Volt Charge Fail at 24 Volts

INPUTS

ALTERNATOR INPUT RANGE
75V(L-N) to 333V AC (L-N) absolute maximum

ALTERNATOR INPUT FREQUENCY
50Hz – 60Hz at rated engine speed
(minimum:75V AC L-N) (Crank disconnect from 15V L-N @ 20Hz)
Over speed +14% (+24% overshoot)
Under speed -20%

OUTPUTS

START & FUEL OUTPUTS
1.2 Amp DC at supply voltage. Switches to battery negative when active

AUXILIARY OUTPUTS
1.2 Amp DC at supply voltage. Switches to battery negative when active

DIMENSIONS

OVERALL
171 mm x 115 mm x 49 mm
6.7” x 4.5” x 1.9”

PANEL CUT-OUT
154 mm x 98 mm
6.1” x 3.9”