Rolling mill bearings 382930 382952 382960 382960X2 382968 382972X2 381030X2 381036X2 381040X2 381050/YB2 381156 381160X2 381160

Four row tapered roller bearing

Many low- or medium-speed rolling mill bearings use four-row tapered roller bearings. Due to its design, this bearing is capable of withstanding axial loads outside of radial loads. In general, no additional thrust bearings are required in the bearing arrangement, the roll journals can be relatively short, and the bearing housings on either side of the rolls can be of the same design. Due to the design of the four-row tapered roller bearing, this bearing must be mounted as a complete bearing on the chock. In order to be able to change rolls quickly, such bearings must be loosely fitted on the roll journal. The disadvantage of the loose fit is that the inner ring creeps on its base under the main load conditions, which usually causes wear of the base with a lower hardness than the bearing ring. In order to reduce the influence of loose fit to a certain extent, that is, to reduce wear, the bearing has a spiral groove in the inner ring hole, and/or an oil groove on the side of the inner ring. These oil grooves feed the lubricant to the contact surfaces of the inner ring and the base. In addition, the grease filled tank absorbs wear particles

Address: No. 24, Lane 397, Huhang Road, Fengxian District, Shanghai, China         

Email：bearing@anshu-electromech.com          Mobile phone:(0086)013918253057

Tel：（0086）021-60140720                     wechate:ch13918253057

Fax：（0086）021-35090027                     QQ：810480122

WhatsApp:+8613918253057                     Skype:chpfchpf